Prolon T1100 Manuals

HARDWARE GUIDE Digital Thermostat Specifications and Operational Guide REV. 7.3.0 PL-HRDW-T1100-F-EN www.proloncontrols.com | [email protected] 17 510, rue Charles, Suite 100, Mirabel, QC, J7J 1X9

T1100 User Guide Ver. 5.1 Introduction The T1100 digital thermostats are networkable, microprocessor-based thermostats designed for zoning applications. Proportional and integral (PI) control loops, working in conjunction with fully customizable outputs (1 analog / 1 digital) deliver accurate yet flexible control strategies. An auxiliary analog input is available for zone temperature averaging or as a radiant floor slab temperature input. Configuration, performed via a capacitive circular touch pad, is made easy through an intuitive menu system displayed on a backlit graphic LCD screen. Installation 1. Open casing to remove back cover by pushing on the tab located underneath the thermostat. (Figure 1) 2. Pull wire(s) through central hole of back cover. 3. Screw in the back cover to the wall. 4. Connect wires: ƒ Pull out the screw terminal blocks. ƒ Remove 1 cm insulation from the end of each wire. ƒ Connect the wires to the terminal blocks: see Figure 2 for pin identification. Typical wiring examples can be found below. ƒ Reinstall terminal blocks. 5. Reconnect top cover Important: Do not install the thermostat under the following conditions: x Any location exposed to direct sunlight x On an outside wall x Near an air discharge grill x In a location where vertical air circulation is restricted x Near a dimmer switch Figure 1 Figure 2 1