PulseWorx RM1-15 Manuals

Model: RM1-15 Receptacle Module Installation Guide and Owner’s Manual The Inventors Of: 19201 Parthenia St. Suite J Northridge, CA 91324 P: 818.701.9831 F: 818.701.1506 [email protected] www.pcslighting.com FUNCTION The RM1 is ideal for remotely controlling one or more 120VAC non-dimming appliances with a maximum rating of 15 Amps. The RM1 will replace any standard wall outlet, the top outlet is controlled. No additional wiring is required. Its lower outlet allows vacuums, computers, and other devices that do not require remote control to be plugged in to the normal electrical circuit. UPB controllers and modules can be freely located anywhere throughout the home. No additional wiring is required and no radio frequency signals are used for communication. IMPORTANT SAFETY INSTRUCTIONS When using electrical products, basic safety precautions should always be followed, including the following: 1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS. 2. Keep away from water. If the product comes in contact with water or other liquid, turn off the circuit breaker and unplug the product immediately. 3. Never use products that have been dropped or damaged. 4. Do not use this product outdoors. 5. Do not use this product for other than its intended purpose. 6. Do not connect multiple lamps or appliances that, when combined, exceed the maximum load ratings of the product. 7. To avoid any risk of fire, burns, personal injury or electric shock, install this product out of the reach of small children. 8. Do not cover this product with any material when in use. 9. This product uses grounded plugs and sockets to reduce the risk of electric shock. These plugs and sockets fit only one way. If they do not fit, consult an electrician. 10. SAVE THESE INSTRUCTIONS. INSTALLATION The Receptacle Module is designed for indoor use with devices that plug into a grounded power outlet. To install the RM1 module: 1. Disable circuit supplying power to outlet at the circuit breaker or fuse panel. 2. Remove the existing wall plate and outlet 3. Label wires connected to existing device. 4. Disconnect existing device. 5. Strip wires have a length of ½” of bare wire. 6. Install device per wiring diagram below. 7. Torque terminal screws to 12-14 inch-pounds 8. Mount the receptacle in to the wall box. 9. Attach wall plate, and then restore power to the circuit. 10. Plug the controlled device into the top socket on receptacle module. The appliance/device current rating must not exceed 15 Amps. 11. Turn the device’s power switch to its ON position. If desired, another device can be plugged into the bottom outlet of the receptacle module, which is always powered. CAUTION: Do not insert metal objects into the module while it is connected to power.