PureAir PCO14-23 Manuals

Page 1 AIR CLEANERS / FILTERS Litho U.S.A. 505,276M 7/2014 Supersedes 2/2012 PUREAIR AIR PURIFICATION SYSTEM PHOTOCATALYTIC OXIDATION (PCO) TECHNOLOGY INSTALLATION INSTRUCTIONS FOR PUREAIR AIR PURIFICATION SYSTEM MODELS PCO14-23, PCO16-28 AND PCO20-28 RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE Shipping & Packing List Assembled PureAir air purification system which includes: 1 - Cabinet 1 - Control box assembly (includes frame, ballasts and associated wiring) 1 - MERV 16 pleated filter 2 - UVA lamps (taped to the cabinet and the insert foil packaging) 1 - Titanium dioxide PureAir Insert 1 - Power cord (120VAC)* *230VAC power cord available separately (part number 91X44). A warranty certificate and registration card are also included. Shipping Damage Check equipment for shipping damage. If damage is found, immediately contact last carrier. General Information The PureAir air purification system uses photocatalytic oxidation (PCO) technology to significantly reduce levels of airborne volatile organic compounds, cooking odors, common household odors, airborne dust particles, mold spores and pollen. The PureAir system is available in three models: PCO14-23, PCO16-28 and PCO20-28. Each unit may be connected to either 120VAC or 230VAC power supply. If 230VAC power supply is used, a 230VAC power cord must be ordered separately. Lab tests confirm a 50% reduction in total volatile organic compounds (TVOC) within the first 24 hours of initial operation of the PureAir air purification system. It may take up to 48 hours after initial system start-up to reduce the airborne chemicals that have built up in a home over a long period of time. For peak performance, unit should be installed in homes with TVOC levels that are less than 1000 micro-gram / cubic meter. Home source removal and ventilation may be required to lower TVOCs to this level. NOTICE This system is NOT intended to be used for removal of active mold growth or continuous sources of high levels of chemicals in the air. For existing mold growth, the mold must be proper­ ly removed PRIOR to installation of the PureAir air purification system. WARNING Risk of property damage, injury, or death. Installation and service must be performed by a qualified installer or service agency. WARNING Electric shock hazard. Can cause injury or death. Disconnect all electrical power supplies before ser­ vicing. Access panels must be in place during ap­ pliance operation. CAUTION Sharp edges hazard. Sharp edges can cause injuries. Use protective gloves when grasping equipment edges. NOTICE Possible odor emissions. Chemical reactions may cause temporary odors after initial start-up or after lamp replacement. Odor may also be present after paint, cleaning solutions or hobby materials have been used in the conditioned space. Some occupants may experience irritation or dis­ comfort during this period. If the irritation or dis­ comfort lasts longer than 48 hours, the homeowner should be advised to contact a Lennox dealer. Unique Field-Supplied Installation Items  Cotton gloves and cloth (to remove finger prints from lamps)  Aluminum foil tape or water-based mastic (NOT silicone) to be applied as a sealant.