QSee QTN8040D Manuals

QTN8040D The QTN8040D is able to accept input from other devices and either pass their signals back to an NVR, or utilize them to trigger recording or alert actions when it is being used in a stand-alone role. # Item Function 1 Inside camera: Storage Focus, Reset Up to 64GB memory Adjust camera’s zoom and focus Reset camera if user is locked out 2 Power For use without POE 3 RJ45 (Ethernet) Port For network connectivity, video output and power input (via POE) 4 PT Controls Connections for addng a Pan-Tllt mount. 5 Alarm 1 Alarm input 1 Output 6 Video Standard Definition video for use in adjusting camera 7 HP (Headphones) Audio out - connect to speaker 8 Mic Input for optional microphone, using included adapter (8a) 9 Temporary Power/Video Connect to circuit board during zoom/ focus setup. MOUNTING THE CAMERA The QTN8040D camera is designed to be mounted on the ceiling. The baseplate is removable to allow for easy installation. Use the included hexagonal wrench to unscrew the retaining bolt half-way. This bolt is located on the front of the camera, above the Q-See logo. Use the self-adhesive template to locate the holes for the mounting screws rather than the baseplate itself to prevent damage. The large circle on the template marks the ideal position to drill a hole for the cables if you will be running them inside the ceiling. The knock-out on the back of the base can be removed if you intend to run the cables along the wall, etc. ADJUSTING THE LENS The QTN8040D has a lens that can be manually adjusted between 2.8mm and 12mm. The 2.8mm setting provides a 109° field of view. The 12mm setting enlarges subjects by approximately three times compared to the 2.8mm configuration, with the field of view narrowing to 22°. The camera is shipped in the 2.8mm position. To adjust the lens, you will have to first remove the camera’s dome by loosening the four screws holding the cover in place. The screws should not be removed from the cover. Once the cover has been removed, you can adjust the Focus (a) and zoom (b) using the two knobs located on the lens body behind the LED circuit board. You may need to loosen them by twisting the knob counter-clockwise before making the adjustments. Do not apply excessive force to the knobs as they can snap off, leaving your camera unable to be adjusted. a b 1 2 3 4 5 6 7 8 8a Once you have drilled the necessary holes, use the included screws and anchors - or other mounting hardware as needed - to secure the base to the surface. Connect the cables and ensure that they will not be pinched when the camera is attached. Attach the camera body to the base and tighten the retaining bolt. Instructions continued on other side Micro SD card - Cards up to 64GB can be used to record still images without the need for an NVR. Two way intercom feature - Connect a microphone and speaker to the correct audio leads- and with similar audio equipment on the user’s end, two-way communication can take place. Alarm - One alarm can be connected to the alarm block with a single output to an audible alarm, an external alarm input or to a NVR. When used with an NVR or on a network, the alarm signal can trigger recording and its signal can be transmitted via the Cat 5e cable to an NVR. 9