Raypak 182-400 Manuals

Catalog No.: 2000.205D Effective: 1-1-08 Replaces: 4-1-05 Job: Engineer: Contractor: Prepared By: Date: Model: Indoor EFFICIENT  82% efficiency – highest of any atmospheric boiler available today THERMAL SHOCK PROOF  Twenty-year warranty against thermal shock damage up to 150°F differential  Maximum operating temperature: 230°F LIGHTWEIGHT  A floor load of 70 lbs./sq. ft. or less HIGH RECOVERY  Cuts fuel costs substantially because the standby and radiation losses normal to other boilers and tank-type water heaters are eliminated LOW WATER OPERATING TEMPERATURE  Operates with water temperature as low as 105°F without condensing Heat Exchanger ƒ ASME Inspected and Stamped 160 PSIG ƒ National Board Approved ƒ Headers Cast Iron Glass-lined – Standard Bronze – Option A-1 ƒ Finned Tubing Copper – Standard Cupro Nickel – Option A-3 ƒ ASME Steel Tube Sheet ƒ Silicone O-Rings ƒ ASME Pressure Relief Valve 45 PSIG – Standard PSIG ASME – Optional ƒ Temperature and Pressure Gauge, Shipped Loose ƒ Water Connections Left Hand – Standard Right Hand – Option A-6 ƒ Flow Configuration – Two-pass ƒ Pump – Optional Mounted, 1/8 HP, 120 Volt, 1∅, 60 Hz Controls ƒ 120V, 60Hz, 1 Ph Power Supply ƒ 120/24V Transformer ƒ 100% Pilot Shut-off/Lockout ƒ Electronic, Intermittent Ignition (IID) Pilot ƒ High Limit Control, Manual Reset ƒ On/Off Switch ƒ Flow Switch ƒ Economaster II Pump Time Delay Gas Control Train ƒ Manual Main Gas Shut-off Cock ƒ Main Gas Pressure Regulator ƒ Redundant Safety Shut-off Valve ƒ Control Valve ƒ Firing Mode On/Off (H4) Two-stage Firing (H3) Mechanical Modulation, 110-170°F (H5) Mechanical Modulation, 150-210°F (H1) ƒ Fuel Natural Gas Propane Gas ƒ Design Certified ANSI Z21.13 Construction ƒ Front Controls ƒ Stainless Steel Burners ƒ Polytuf Powder Coat Finish ƒ Vent Selection Draft Diverter – Option D-10 Power Vent, Loose – Option D-2 ƒ Base (Optional) Combustible Floor Shield – Option J-1 Temperature Controls Note: H1 and H5 do not require a controller B-6 Two-stage – 100-200ºF Y-241 Electronic Sequencer, 1-4 Stages Y-281 Electronic Sequencer, 1-8 Stages Additional Safety Controls F-10 Low Water Cut-off Probe I-1 High Limit Control, Auto Reset, 240°F S-1 Low Gas Pressure Switch, Manual S-2 High Gas Pressure Switch, Manual Regulatory Agency Requirements Raytherm® - Type H Hydronic Heating Boilers Models 182-400 - Indoor Catalog No.: 2000.205D Effective: 1-1-08 Replaces: 4-1-05 Raytherm - Type H Hydronic Heating Boilers - Indoor Model K (C) INDOOR DRAFT 38" 13-1/4" GAS CONNECTION 26-1/2" 10-1/4 3-7/8 3-7/8 26-1/2" 40" 21-1/4" ELECT. CONN STACKLESS OUTDOOR TOP PUMP (OPTIONAL) PUMP COVER (OPTIONAL) J 3/4 NPT GAS CONNECTION (OUTDOOR MODELS ONLY) 11" Dimensions (Inches) Shipping Weight (Lbs.) – Approx. Model No. MBTU Input MBTU Output AFUE* (%) Width A Height C J Flue Dia. K No Pump w/ Pump H-182 181 148 82.6 18-1/4 62-5/8 12-1/16 6 191 221 H-260 264 216 82.7 22-3/8 62-7/8 11-1/8 7 214 244 H-330 334 274 N/A 25-3/4 63-3/4 10-3/4 8 234 264 H-400 399 327 N/A 29-1/4 65-3/8 12-1/2 9 253 283 * With Vent Damper NOTE: Ratings shown are for elevations up to 2,000 feet. For elevations over 2,000, reduce ratings at the rate of 4% for each 1,000 feet above sea level. BOILER RATE OF FLOW AND PRESSURE DROP 10° ∆T 20° ∆T 30° ∆T Model No. GPM ∆P FT GPM ∆P FT GPM ∆P FT H-182 30 4.2 N/A N/A N/A N/A H-260 43 8.5 22 2.2 N/A N/A H-330 N/A N/A 27 3.4 N/A N/A H-400 N/A N/A 33 5.2 22 2.3 N/A – Not Applicable Raypak, Inc. ƒ 2151 Eastman Avenue, Oxnard, CA 93030 ƒ (805) 278-5300 ƒ Fax (800) 872-9725 ƒ www.raypak.com