RDS Pro Series Manuals

ARTEMIS PSi QUICK REFERENCE GUIDE PT NO. S/DC/500-10-731 : ISSUE 1.00 : 2/7/13 : UK731100.DOC “Tramline Bouts” The Wheel Marks display a tick when on a tramline bout and which side is active. The Second line shows the current Tramline Bout. The Third line shows the Tramline Target. “Power On / Off“ Button Turns the Artemis on and off. “Pre-Start” This button starts the metering motor running to prime the seed pipes prior to the drill entering the ground or moving forward. “Tramline +1 Bout” Button This button will override the current Tramline Count and add 1 bout the current Tramline Bout. “Setup” Button Used to enter the Setup/Configuration Menu “ENTER” Button When you have typed in a new Target Rate on the RATE page, press this button to enter it. “SD/MMC Card Reader” “Forward Speed” This displays the live Forward Speed Reading. If the speed is too high or too low then it will alarm and show an up/down arrow. “Tramline Hold” Button This will prevent the tramline bout counting on if the drill is lifted while working in the field. “Return to MAIN Screen” Press at any time to return from the Rate screen or any other screen, back to the ‘MAIN’ Artemis screen displayed here. Press to switch between Fan 1 & Fan 2 while on the MAIN page if using twin fans. Numeric Keypad Used to enter a 'Target Rate' while on RATE page. If the Target Rate displayed is incorrect, just type in a new one, finishing with the Enter key. Use also for keying in a value within Setup Menu. “Seed/Fert Motor On / Off” Buttons These buttons allow the metering motors to be independently switched on or off. These buttons will override the cut out status on the drill. “Fan Speed” This is the Fan RPM Speed. If this drops below the preset Alarm threshold then the system will alarm and the Metering Motor will not run.