Document Preview & Text Transcription
12
USB INTERFACE
USB Standard
USB1.1/2.0 (Full Speed)
Maximum Supply Current
500mA
File System
Fat16/32
Decoding Format
same as CD
SD CARD INTERFACE
Frequency Response (+/- 1dB)
10 – 20,000Hz
Dynamic Range
80dB (1kHz)
Harmonic Distortion
0.01%
Decoding Format
same as CD
AUDIO PRE-AMP SPECIFICATIONS
Max Output level
5V
Output Impedance
600Ω
Subwoofer output
Not adjustable
AUXILIARY INPUT SPECIFICATION
Frequency Response (+/- 1db)
20HZ – 20Khz
Input Voltage Maximum Voltage
1200mV
Input impedance
10KΩ
Radio Engineering Industries, Inc.
Radio Engineering Industries, Inc.
6534 “L” Street
Omaha, Nebraska 68117
Phone: 402-339-2200 Toll-Free 1-800-228-9275
www.radioeng.com
Rev 0.2
02-28-13
AM/FM/CD/MP3 Weather Band Radio Receiver with USB/SD &
Auxiliary Inputs, 3 Built-in Microphone inputs for PA
Announcements
Installation/Operation Manual
50W x 4
CD-3000
2
Thank you for purchasing the CD-3000 AM/FM/CD/MP3/USB/SD Receiver from REI.
This product is designed and tested to withstand temperature and vibration extremes.
Please read the owner’s manual carefully before attempting to install.
If you have an installation question or need installation assistance, please call the:
SERVICE HOT LINE
1-877-726-4617 Toll Free USA & CANADA
1-402-339-2200
FEATURES:
30s Anti-skip CD Mechanism
Front-panel SD/SDHC CARD & USB Type-A inputs
Supports MP3/WMA playback
Displays ID3 tag information
50W x 4 Output power
Non-volatile memory back-up stores user Presets when the battery is disconnected
7 channel NOAA® Weather Band Tuner
Electronic AM/FM Stereo Tuner
EURO and USA frequency bands
Radio Station Lock-Out
12/24 hr Clock modes
Presets Up to 30 Radio Stations (18 FM, 12 AM)
Two Independent Aux Inputs (Front 3.5mm Stereo Jack/Rear RCA)
Electronic Bass, Treble, Balance, and Fader Controls
LED Backlighting
Integrated PA Microphone inputs (Microphones & Adapters Sold Separately)
Rear Channel Pre-amp outputs
IR wireless Remote Control Ready (Remote and IR extension cable sold separately)
IF ADDITIONAL INSTALLATION COMPONENTS ARE NECESSARY, CONTACT YOUR REI
SALES REP FOR:
** OEM /FACTORY WIRING HARNESS ADAPTERS
** ANTENNAS & ANTENNA ADAPTERS
** SPEAKERS & GRILLS
Radio Engineering Industries, Inc.
6534 “L” Street
Omaha, Nebraska 68117
www.radioeng.com
11
SPECIFICATIONS:
General Specifications
Operating Voltage
(10.0 –15.6V allowable)
Maximum Current Consumption
10A
Standby Current Consumption
10mA
POWER OUTPUT
Continuous Output (4Ω, 20 to 20,000 Hz at 1% THD)
4 x 25 Watts
Maximum Power Output (at 1kHz)
4 x 50 Watts
Speaker Impedance
4-8 Ohms
FM STEREO RADIO
Frequency range
USA 87.5MHZ – 107.9MHZ (0.2 MHz step)
EURO 87.50MHZ –108.00MHz (0.05 MHz step)
Usable Sensitivity
10.2 dBf. (0.9 uV, 75Ω)
50db Quieting Sensitivity
15.2 dBf. (1.6 uV, 75Ω)
Stereo Separation
40dB (1kHz)
AM RADIO
Frequency range
USA 530kHz – 1710kHz (10 kHz step)
EURO 522kHz – 1620kHz (9 kHz step)
Usable Sensitivity
27 dB/uV (25uV, S/N 20dB)
Signal to noise ratio (LEVEL60dbuV) 51 dB
WEATHER BAND TUNER
Range
162.400 –162.550MHz
Usable Sensitivity
(S/N = 20dB) 0.7uV(-9dBuV)
Signal to noise ratio (LEVEL40dbuV)
42dB
CD/PLAYER
Signal/Noise Ratio (1kHz)
75dB
Frequency Response (+/- 1dB)
5 – 20,000Hz
Total Harmonic Distortion (1kHz)
less than 0.20% (1Khz)
Number of Channels
2 (stereo)
MP3 decoding format
MPEG-1 & 2 Audio layer 3
WMA decoding format
Ver. 7, 7.1,8,9,10,11 (2ch audio)
(Windows Media Player)
Usable Discs:
SVCD, CD-R/RW, CD-Audio,
CD-MP3, CD-WMA
10
RADIO REMOVAL
3. To remove the radio, disconnect the rear support stud if installed. Carefully
release the front Trim Ring lock tabs at the top and bottom of the nosepiece. Then
insert the two release keys on both sides of the nosepiece and pull the radio out.
TROUBLESHOOTING
Problem
Cause
Measure
Power light does not turn on
No power to yellow wire; no power
to red wire; blown fuse
Check for ACC/BATTERY
voltage with Multi-meter, check
fuse; press RESET button.
No sound
Speakers not connected; speakers
connected with bad splices;
Speakers shorted to ground; total
speakers load not within 4-8Ω/ch
Connect speakers to harness;
check all spliced wires; verify
speakers not shorted to chassis;
verify total speaker impedance.
Public Address can NOT be
heard over speakers
Microphone volume level is “0”;
microphone is plugged into the
wrong input; wrong microphone
type is used
Turn the volume up when the
LCD display’s MIC 1 or MIC 2;
Check that the correct
microphone type is connected
Digital media won’t play or
says “ERROR” and skips to
“AUX”
Media is an unsupported file type.
Encode media with a supported
file type; make sure disc has
been finalized; use different
software
Disc errors during CD playback
Disc is scratched, internal optics
dirty, or the angle of operation is
too extreme.
Restore the CD by removing the
scratches. Adjust the angle of
operation to between 0°-30°.
LCD Display says MIC /MIC 1/
or MIC 2 and front controls are
locked
PA system is triggered
Remove microphone connections
and verify correct pinning;
replace microphone
3
CONTROLS AND INDICATORS
(1)
Power Button
(2)
Volume/Select Knob
(3)
Band Button
(4)
Mode Button
(5)
Reset Button
(6)
Scan Button
(7)
Preset Memory Buttons/r Playback Options
(8)
Mute Button
(9)
Radio Station Tune/Seek, Track Control Buttons
(10) Front Auxiliary Input Jack
(11) SD Card Input slot
(12) Display Button
(13) Clock Button
(14) USB Input Slot
(15) Eject Button
