resideo Honeywell Home HM700ADISTKIT Manuals

INSTALLATION INSTRUCTIONS 33-00160EFS-05 HM700ADISTKIT ELECTRODE STEAM HUMIDIFIER DISTRIBUTION KIT CAUTION Before Servicing 1. Disconnect main power source before accessing internal compartments. 2. The plumbing and electrical compartments contain high voltage components and wiring. Access should be limited to licensed HVAC professionals only. 3. During and following operation of the humidifier, the steam components in contact with the steam such as the cylinder, steam lines, steam distributors, and condensate lines can become hot and burn if touched. Please consult HM700 Installation manual for reference. 4. Humidity equipment installed by unqualified personnel or the use of parts and components not supplied with the humidifier or this kit will void warranty. Steam Distributor The HM700ADISTKIT is a remote mount, stainless steel steam distribution kit used with the HM700 Electrode Steam Humidifier. The distributor is installed in a ventilation duct to distribute the steam produced by the HM700. The HM700ADISTKIT consists of a steam distributor, steam hose, condensate hose, and installation hardware. The steam distributor should be installed as close as possible to the humidifier. Short steam distribution lines minimize condensate loss and the possibility of generating backpressure in the steam distribution line. STEAM DISTRIBUTION Steam generated by the humidifier may be introduced into the air in several different ways. The most common method for adding the steam into the air is to mount a steam distributor tube in a supply air duct as shown in Fig. 2. STEAM LINE The steam line between the cylinder steam outlet and the distributor serves two purposes: it is used as a conduit to transfer the atmospheric steam from the humidifier to the distributor, as well as providing a means to remove condensate. See “Steam Lines and Condensate Return Instructions” on page 2 for information on selecting steam lines. CONDENSATE RETURN Whenever steam is distributed condensate is formed in the distribution system. Insulating steam lines is one important way to reduce the amount of condensate formed. Steam lines are sloped so that condensate does not collect in the lines and create a restriction to steam flow. The condensate must be collected and removed from the system so that it does not build up and leak into the duct. Condensate can be returned to the HM700 fill cup to reduce water waste or can be fed to drain. KIT CONTENTS: • Stainless steel nozzle • Insulated hose (5 ft.) • Hose support brackets • Screws • Clamps • Installation Instructions TOOLS NEEDED (NOT SUPPLIED): • Screwdriver • Pliers (optional)