resideo Protectorelay Manuals

INSTALLATION INSTRUCTIONS 69-0618-04 R4184D; R8184G,M,N,P Protectorelay® Oil Primary Controls APPLICATION The intermittent ignition R4184D and R8184G,M,N,P Oil Primary Controls operate the oil burner, oil valve (if desired) and the ignition transformer in response to a call for heat from the thermostat. The R8184M also provides automatic, nonrecycling control of cooling systems and low voltage thermostat. The R8184P provides 15-second valve on delay and selectable 0-, 2-, 4-, 6-minute blower off delay for hydronic and warm air systems. Select models have 30- minute blower off delay timing. All models use the C554A Cadmium Sulfide (cad cell) Flame Detector to monitor the burner flame and shut down the system on ignition failure or on flame failure during the run cycle. A manual reset button is provided to reset the safety switch after lockout. Clock thermostats (not available on R8184P) that power the clock through the primary control transformer lose time during lockout unless backup batteries are installed. All models (except the R8184G1310 and R8184G1328) are Underwriters Laboratories Inc. component recognized and meet flammability test requirements for a final enclosure. NOTE: R8184P is intended for use on oil burning appli- ances that do not require a safety rated pre- purge and postpurge function as defined in UL 296. The valve on delay and blower off delay in this control are only intended to help establish draft and reduce oil after drip-related problems. INSTALLATION When Installing This Product… 1. Read these instructions carefully. Failure to follow them could damage the product or cause a haz- ardous condition. 2. Check the ratings given in these instructions to make sure the integrated furnace control is suit- able for your application. 3. Installer must be a trained, experienced service technician. 4. After completing the installation, use these instructions to check out the product operation. CAUTION 1. Disconnect the power supply before beginning installation to prevent electrical shock or equipment damage. 2. Be sure the combustion chamber is free of oil or oil vapor before starting the system. Location 1. Mount on a 4 x 4 junction box, directly on the main burner housing or inside the appliance cabinet. See Fig. 1. 2. Be sure that operating temperatures are between -40°F and +130°F (-40°C and +54°C). Select R8184G,P models have a maximum temperature of 150°F (66°C), but must be mounted parallel to the ground to achieve 150°F (66°C). See Fig. 2. Fig. 1. Wire and mount 130°F (54°C) maximum ambient temperature oil primary control. CAD CELL LEADS LINE VOLTAGE LEADS MOUNTING SCREW HOLE RED RESET BUTTON 4 x 4 JUNCTION BOX HOLE OR KNOCKOUT FOR CAD CELL LEADS LOW VOLTAGE TERMINAL STRIP 1 STRIP WIRES 3/8 in. (9.5 mm); INSERT FROM SIDE, ABOVE OR BELOW. T-T TERMINALS ON R8184G; T1-T2 TERMINALS ON R8184N. 1 2 2 M1643D