Resolution CryptiX RE601 Manuals

RE601_Cryptix-Compat_DWS_Instructions 24-Hour Tech Support Line: (715)808-0164 26-Feb-15 www.ResolutionProducts.com Installation Guide RE601 CryptiX™-Compatible Standard Door / Window Features • For sensing things that open or separate • Strong, reliable RF signal • 10-15 year battery life • Cover tamper • Low Battery indication • 3 total zones • Main reed switch + magnet • 2 Optional External Contacts Enrollment • Place panel in enrollment mode. • Sensor enrollment signal can be sent by one of these two ways. • Remove the battery tab. • Pull cover off to tamper device. • To set up zone and configure the sensor, log into the web based dealer portal Installation • Place sensor on a door or window using the mounting holes. • Below are recommendations for sensor locations. Mounting holes RE601_Cryptix-Compat_DWS_Instructions 24-Hour Tech Support Line: (715)808-0164 26-Feb-15 www.ResolutionProducts.com • Mount the sensor with magnet on the side of the sensor with the mark as pictured below. Optional External Contact Mounting and Wiring • Optional External contact wiring. • External Input #1: Outer Terminal Zone + Center Common Terminal • External Input #2: Inner Terminal Zone + Center Common Terminal • Optional external contact zones are: normally closed – alarm on open. • No end-of-line resistors on external contact zones. Note: External contacts not evaluated by ETL Outer Terminal Zone External Input #1 Center Common Terminal Inner Terminal Zone External Input #2 Magnet rests in drilled hole on top of door. External contact is wired to the door window sensor through a hole drilled in the doorframe Magnet Mark