RightAngle 200CPU Manuals

FOR THE HEIGHT, WIDTH, & DEPTH OF YOUR CPU. MAKE SURE THE CPU HAS PAGE 1 OF 3 ENOUGH CLEARANCE TO ROTATE LEFT & RIGHT AS FAR AS YOU WANT IT TO 1 VERSION DATED: 8/15/11 ROTATE. STEP 2: REMOVE THE CPU HOLDER FROM THE TRACK SQUARE 2 TAPE MEASURE #2 SQUARE HEAD DRIVER BIT #2 PHILLIPS DRIVER BIT OR CORDLESS DRILL TOOLS REQUIRED FOR ASSEMBLY: READ ALL THE INSTRUCTIONS BEFORE BEGINNING BY SLIDING IT OUT TOWARD THE FRONT AND SET IT ASIDE. STEP 3: HARDWARE PACK # 50519 EXPOSE THE GLUE DOTS ON THE TOP OF THE TRACK 1 BY PULLING THE PAPER STRIPS OFF THE TRACK. POSITION THE TRACK IN THE LOCATION SHOWN AND PRESS IT FIRMLY IN PLACE SO THE GLUE DOTS WILL HOLD THE TRACK TO THE BOTTOM OF THE WORKSURFACE. IMPORTANT NOTE: THE WORKSURFACE MATERIAL MUST BE COMPATIBLE WITH THE SCREWS PROVIDED. THE WORKSURFACE MUST BE AT LEAST 1" THICK. INSTRUCTION # 50576 STEP 4: ATTACH THE TRACK 1 . DO NOT OVER-TIGHTEN THE SCREWS. USE A LOW TORQUE TO THE WORKSURFACE WITH (4) WOOD SCREWS SETTING ON THE DRILL. 200CPU HOLDER INSTALLATION INSTRUCTIONS: STEP 1: DETERMINE THE LOCATION TO MOUNT THE CPU HOLDER ALLOWING ITEM # PART # DESCRIPTION QTY. 1 50093 16" TRACK ASSY 1 2 51708 M5 x 18mm SQ/PH/WSHR HEAD WOOD SCREW 4 3 200CPU ECONOMY CPU HOLDER 1 4 52679 8-32 x 3/8 PHILLIPS TRUSS HEAD MACHINE SCREW 2 5 50330 #20/3 WIRE PULL HANDLE 1 6 50232 FRONT STOP 1 7 50200 10-24 x 1/2 SELF TAPPING MACHINE SCREW 2 6703 ZINSER ST., SCHOFIELD, WI 54476 PHONE: 800.298.4351 FAX: 866.882.9475 www.raproducts.com K&A MANUFACTURING 1 PAPER STRIPS COVERING GLUE DOTS STEP 3 WORKSURFACE AND BACK 3/8" WITH THE FRONT OF THE 1 2 PLACE THE TRACK SQUARE BOTTOM OF WORKSURFACE STEP 4