ring Video Doorbell 3 Manuals

Physically installing your Ring Video Doorbell 3 with an existing doorbell is a simple process. Simply scroll down for a step-by-step guide. Note that you should set up your Ring Video Doorbell 3 in your Ring App before mounting it to your home. Click here for information on setting up your Ring Video Doorbell 3 in the Ring app. Click here to see the full installation video. Step One: Charge the provided battery Fully charge the battery by plugging it into a USB power source using the provided orange cable. When only one of the two LEDs on the battery is lit, the battery is fully charged. Insert the battery into the bottom of your Ring Doorbell 3 until it clicks into place. Click here for more information on charging your Ring battery. Note: You may see an incorrect battery discharge/reporting when setting up your Ring Video Doorbell 3 if the device is not fully charged before use. Please charge the battery completely before setting up your device. Step Two (If installing without an existing doorbell): Select your install height Install Video Doorbell approximately 1.2 metres above the ground for optimal performance. If you’re connecting to existing doorbell wiring that’s higher than 1.2 metres, thus limiting where you can install your new Doorbell, use the provided wedge mount to angle your Doorbell down. Skip to Step Three. Step Two (If installing with an existing doorbell): Remove your existing doorbell If replacing an existing doorbell, shut off power to your doorbell system at the breaker. Then remove the doorbell button from the wall and disconnect the wires. Note: If wiring your Ring Doorbell 3 to an existing doorbell, a transformer with a voltage of 8-24 VAC, 40VA max, 50/60Hz is required.

1 Video Doorbell 3

1 Video Doorbell 3 guide om