Rosslare LK-M03 Manuals

LK-M03 MAGLOCK 300 LBS June 2012 Installation Manual 1 1. Introduction The LKM03 is a surface mounted magnetic lock series with 300 lbs holding force. LKM03 has dual voltage (12 or 24 VDC) and low current consumption with anodized aluminum housing. LKM03 has a built-in voltage spike suppressor and no residual magnetism. Different types of bracket and housing are available to fit various mounting conditions. LKM03 is compatible with EN55011:1998: Class B, EN60601-1-2:2002, EN61000-4-2:1995, EN61000-4-3:2002 & UL-S5351. Figure 1: LKM03 2. Technical Specifications 2.1 Electrical Characteristics Power Supply Voltage Dual Voltage: 12/24 VDC Current Draw: 12 VDC: 360 mA 24 VDC: 180 mA 2.2 Physical Characteristics Holding Force ~300 lbs Dimensions (L x W x D) 166 x 38.6 x 21.5 mm (6.54 x 1.52 x 0.85 in.) Weight 11.2 kg (24.69 lbs) 3. Mounting Before attempting to install magnetic lock:  Handle the equipment with care. Damaging the mating surfaces of the magnet or armature plate may reduce locking efficiency.  The magnet mounts rigidly to the door frame. The armature plate mounts to the door with hardware. Kit provided that allows it to pivot about its center to compensate for door wear and misalignment.  Template use must take place with the door in its normally closed position.  Before installing, please add the thread locker to all screws. Firmly tighten the screws to avoid fastening loosen. 3.1 Surface Mounting Typical surface mountings are shown in Figure 2. Figure 2: Surface Mounting Figure 3 shows how to mount an armature plate/surface. Figure 3: Armature Plate/Surface Mounting 3.2 Mortise Mounting Fix the armature plate not too tightly and make the rubber washer more flexible to make the armature plate automatically adjust its proper position with the magnet. Typical mortise mountings are shown in the following figures. Figure 4: Magnet/Sliding Door without Mounting Plate Figure 5: Use for Magnet/Sliding Door Figure 6: Use for Armature Plate/Sliding Door 4. Wiring To wire input: 1. Connect the ground (-) lead from the power source to white wire of PCB. 2. Connect the positive (+) lead from the power source to red wire of PCB. Figure 7: Wiring 3. Set jumper to either 12 or 24 VDC, depending on the power source. Figure 8: Jumper Settings