RS Advantage 6 Manuals

Introduction The remote keypad is an electronic switching device which can be fitted as an accessory for the Advantage 6 control panel and has been designed to fit into a single gang back pattress (not supplied), which can be either flush or surface mounted. The remote keypad can be wired using a 4-core cable (if the tamper circuit is not required), or wired with 6-core cable if a tamper circuit is required between the main control panel and the remote keypad. The unit has been designed simply to arm, disarm and part-arm the system. It is not possible to change the systems programs using the remote keypad. The remote keypad is supplied with an attractive white finishing plate to blend in with existing surroundings the remote keypad is also back illuminated to facilitate ease of use during evening time or when fitted in dark areas. Up to 6 keypads can be used on one panel. Installation We recommend that before beginning the installation work these instructions are read carefully. Note: DO NOT USE A METAL PATTRESS. Position the remote keypad at a height that allows ease of use. The same height of a light switch would be suitable, run a 4 or 6-core cable (if tamper is in use) from the main control panel to the remote keypad, taking care not to run the cable adjacent to mains (230V) cable, feed the cable into the pattress and then secure the pattress to the wall. At the control panel 1. Isolate the panel from the mains supply. 2. Type in your engineer code. 3. Unscrew the front cover of the alarm panel. 4. If your alarm has a sounder with SAB unit fitted it is advisable to disconnect the SAB battery. 5. Disconnect the battery from the alarm panel. 6. Connect the small driver board as shown in figure 1. 7. Now connect the keypad as shown in figure 2. Note: If you use the 24 hour tamper circuit you need to connect the keypad in series with the other devices connected in the circuit. 8. If more than one keypad is required then the connections should be made in parallel apart from the 24 hour tamper circuit that should be connected in series. Advantage 6 Remote Keypad Stock No. 437-654 Figure 1. Driver board connection RT SWITCHED POSITIVE STROBE + STROBE - BELL + BELL - SPEAKER NVM RESET BELL/STROBE F3 SPEAKER AUX. F2 BATTERY F1 AUX + AUX - BATTERY + RED BATTERY - BLACK AC AC TRANSFORMER SCB 24 hour KEYSWITCH PA ZONE 6 ZONE 5 ZONE 4 ZONE 3 ZONE 2 ZONE 1 (Entry/Exit) SA12 SA12 SA12 4001 +12 6 0V 7 SP- 13 KS 21 TAMP 14 15 220uF + 220uF + 78L05 PB Tamper switch Figure 2. Keypad panel connections A B A. Driver board B. Alarm panel PCB Remote keypad and control panel connections