RTA TECHNI MOBILi RTA-1305 Manuals

MODEL RTA-1305 Thanks for purchasing one of our products. Please read carefully the assembly instructions before the installation. Please save this manual for future reference. ASSEMBLY INSTRUCTIONS P.1 P.1 RTA-1305 P.2 P.2 MAIN PARTS LIST NOTE: PARTS (1) AND (2) ARE EXACTLY THE SAME NOTE: PARTS (3) AND (4) ARE EXACTLY THE SAME RTA-1305 P.3 P.3 21 17 14 9 19 15 23 22 9 20 16 Small Stud Large Stud Wooden Pin HARDWARE LIST PARTS LAYOUT: RTA-1305 P.4 P.4 ☛Do a quick inventory to make sure the product contains all the parts and hardware. ☛Missing, damaged and defective parts can be replaced at no cost to you. Please refer to the CONTACT and the WARRANTY cards included with the product. ☛If during assembly you find an issue or need clarification, please contact our Customer Service for assistance. Please refer to the CONTACT card included with the product. ☛On each step read the instructions and analyze the illustrations thoroughly before proceeding to do the assembly. ☛To avoid misalignments, always leave the screws loose and tighten them until all pieces are positioned correctly. ☛Do not overtighten or force the screws as they might break, strip, damage the threads of the holes or get stuck inside the part. ☛Sometimes the laminate might cover partially or entirely the hole on a panel, but the hole should still be located under the laminate. ☛If there is no visible hole for the screw, pass and press the tip of your finger over the area where the hole should be located to feel the indentation, and once found, carefully pierce the laminate to reveal the hole underneath. ☛If the hole seems too small for the screw, first make sure you are using the correct size of screw and that it’s been installed in the correct hole. If the hole still appears to be too small, carefully pierce the laminate to reveal the hole’s actual size. ☛This unit uses cam bolts and locks. The following page explains how to work with this kind of hardware. ☛Make sure you understand which hardware will be used on each step. Using the wrong size of screw, bolt or pin might cause damage to the part in which it is being used. ⚠BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS AND WARNINGS.