Safety Basement SB-CVR4000 Manuals

INSTRUCTION MANUAL Revised: September 13th, 2013 SB-CVR4000 FRONT BACK Camera Microphone ON/OFF RECORD MODE switch V - Video P - Picture BEFORE YOU START Before you use your Cross DVR you will do the following: • Plug your DVR into your PC • Charge it fully • Download time files from www.SafetyBasement.com • Set your timestamp on the DVR CONNECT YOUR CROSS TO PC Use the included USB cable. Connect one end to the USB port in your pen. Connect the other end to a USB port on your PC. Please do not use a hub. In a few moments, your PC will connect to your pen. Your PC may install standard drivers the first time it connects. This is normal. No additional drivers are required. The status light will appear while connected to your PC. Your Cross DVR is now charging. and also ready to download any files from it to your computer CONNECT YOUR CROSS DVR TO When you connect your DVR, on many Windows computers, a pop up window will appear called AUTOPLAY. This is normal. Just choose OPEN FOLDER as shown. Your DVR will appear as an External or Removable Drive with a drive letter, such as E:. Your letter may vary. You will see VIDEO, IMAGE folders. Your recordings will be saved in these folders. We will access them later in the manual. Please keep this window open for the next step. Your Pen DOWNLOAD FILES Go to the same section you downloaded this user manual Right-click on the SETTINGTIMETOOL file, and choose SAVE LINK AS, or SAVE TARGET AS... Save the file to your DVR, as shown in this example. In the same areas as the folders Once you have saved this file there, double click it, in its new location, and that should sync the time with your computer time. Unplug your device from your computer. Your video files should have the correct time stamp when you turn it now next. NOTE: We always recommend that you record a small time file and play back just to make sure your time has been adjusted, just incase you didnt do it correctly.