Safety Systems LTCMIP183 Manuals

Covert Network Camera Quick Installation Guide 1 2 6 8 7 ALARM RS232 RXD TXD GND IN1 1B 1A LAN(PoE) DC 12V RESET SD VIN1 AUDIO OUT AUDIO IN 9 10 11 12 13 14 15 16 17 18 1 2 3 4 5 ALARM RS232 RXD TXD GND IN1 1B 1A LAN(PoE) DC 12V RESET SD VIN1 AUDIO OUT AUDIO IN 9 10 11 12 13 14 15 16 17 18 Covert Camera with Cylindrical Sensor Covert Camera with Fixed Focal Unit Covert Camera with Block-shaped Sensor Installation of Main Unit 1. Fix the standard mounting rail on the mounting surface. 2. Hang the hook which is on upper-side of the main unit onto the rail, press a little harder on the lower part of the main unit, and then the elastic clasp will be automatically buckled.As shown in below left figure. If you already had a standard rail to be installed, you can buckle the main unit onto the installed rail directly.As shown in below right figure. Installation of Block-Shaped Sensor Unit 1. Drill on the mounting surface.As shown in below left figure. 2. Remove a side of the adhesive tape on the bracket. Paste the bracket on the mounting surface with aligning with the drilling hole.As shown in below right figure. 3. Install the Block-shaped sensor unit into the bracket and make it to be buckled. 4. Tighten the fastening screw on the top of the bracket. No. Description No. Description 1 Main Unit 11 PoE & Network 2 Power Indicator LED 12 Mounting Rail 3 Status Indicator LED 13 Block-Shaped Sensor Unit 4 Link Indicator Led 14 Decorative Cover 5 Audio Interface 15 Straight Mounting Bracket 6 RJ-12 Cable 16 Cylindrical Sensor Unit 7 Micro SD Card Slot 17 RJ-12 Interface 8 RESET Button 18 Round Rail Mounting Bracket 9 RS-232 &Alarm Interface 19 Fixed Focal Camera 10 Power Interface 20 Ceiling Mounting Bracket Note: Press RESET button about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc.