Santec ALEXIS 2320HA Manuals

Installation Instruction Widespread Lavatory Set ALEXIS COLLECTIONS Please read the instructions completely before beginning the installation. Alexis Collection Model Number: 2320HA Alexis Crystal Collection Model Number: 2320HC Flush both supply lines before installation, then shut off both supply lines. Minimum hole size for the spout and handle trim is 1-1/4” and maximum of 1-1/2” - Remove the tee connector, spout mounting hardware and tee connector washer from the bottom of the spout assembly. Apply a ring of silicon caulking around the center hole on the top of the sink. Do not use plumbers' putty which can damage the finish of the faucet. - From the top of the deck, insert the spout's threaded shank through the center hole of the sink. Make sure the spout flange washer is properly placed underneath of the flange and gently pressed against the sink top. 1 Rev 06/2016 The measurements shown are for reference only. Products and specifications shown are subject to change without notice. www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681 SPOUT INSTALLATION - Slip the spout mounting hardware back onto the spout. First the notched rubber washer, then the notched metal washer and lastly the brass lock nut. Hand tighten the lock nut. - Place the pop-up lift rod with the knob through the back hole in the spout and rotate the notched washers until the lift rod passes through the notch. - Tighten the lock nut. Make sure the lift rod operates smoothly. Adjust it if necessary. - Place the tee connector washer into the tee connector and thread the tee connector onto the end of the spout shank. Tighten to seal. - Align the spout and tighten the shank lock nut firmly. 2 Rubber washer 1/7 Notched rubber washer Notched metal washer Spout stabilizer Brass lock nut Tee connector Tee connector washer