Sanyo VA-DK02 Manuals

■Installation method Make a hole with a diameter of 200 mm in the ceiling, install the hook of the accessory safety wire (A) into the hooking hole (B) of the bracket, and then install the other end of the safety wire (A) to a point inside the ceiling. Install the bracket to the ceiling, and then use a screwdriver to fully tighten both of the screws (C). Secure the ceiling surface with the bracket (D). (B) (A) 200 mm (Y) (C) (C) (D) 2 1 Remove the basement (Z) from the camera bottom, secure it by tightening the two supplied screws and then install the mini dome camera to it. Remove the basement (Z) from the camera bottom, install the accessory spacer (E: 12mm) to it, secure it by tightening the four supplied screws and then install the mini dome camera to it. Install the three spacers (F: 22 mm) which are supplied with the In-ceiling bracket, install the camera into the In-ceiling bracket, and then secure it by tightening the three supplied screws. (Z) (E) (E) M4×10 mm M4×10 mm (Z) Insert the hook of the safety wire which is attached to the cover into the hooking hole (G) of the In-ceiling bracket. Push both hooks (H) of the cover, and then align the cover with the ceiling and turn it clockwise to secure it. (H) (H) 5 (G) 4 M4×10 mm (F) (F) Install the camera. Four types of camera can be installed to this bracket. Place the camera into the In-ceiling bracket, and then secure it by tightening the four supplied screws. M4×10 mm 3 essories 4 (M4×10 mm) : 4 (12 mm), 3 (22 mm) ires: 2 cifications 550 g ons (Unit: mm): φ230×105 (H) g board thickness range: 5 - 30 mm specifications are subject to change without r obligations. H ø ③ ② 75-- (1107KR-TT)b -DK02 iling bracket RUCTION MANUAL ting the installation procedure, please read these instructions carefully. Make sure to instructions handy for future reference. ety Precautions alling the bracket and camera, select a surface which is flat and durable and which can support ight of the bracket and camera, and make sure that they are installed securely. llation location is plasterboard or a similar material, use a reinforcement plate to reinforce it. ket and camera are not securely installed, they may fall down. lling the bracket and camera, always be sure to check that they are fully secure. If the bracket ra falls down, serious injury may result. ¡If the safety wire is too short, use the other safety wire which is also included as an accessory. The safety wire is used to prevent the bracket from falling down once it has been installed. ¡If the installation location is not strong enough, reinforce the ceiling, or install the anchor bolt (Y). A Installing the vandal resistant dome camera B Installing the pan-focus indoor mini dome camera C Installing the vari-focal indoor mini dome camera Be sure to remove the rubber cushion on the base of the mini dome camera. SANYO Electric Co., Ltd. Printed in Taiwan When installing the cover to the ceiling, the hook of the safety wire may become clamped between the hooks (H) and the hooks (H) may open. If the hooks (H) are open when the cover is installed, the cover may fall down. WARNING This indicates a point that if not respected may cause death or serious injuries. CAUTION This indicates a point that if not respected may cause injuries and/or extensive material damage. D Installing the vandal resistant mini dome camera BHL_WA_E 07.11.16 3:18 PM ページ 1