SDC LR100ARK Manuals

P:\INSTALLATION INST\SWITCH KITS\INST-LR100ARK.vsd REV - 12-19 Page 1 INSTALLATION INSTRUCTIONS LR100ARK ADAMS RITE ELECTRIC LATCH RETRACTION DEVICE KIT RIM EXIT DEVICE MODELS: 3700 & 8800 801 Avenida Acaso, Camarillo, Ca. 93012 • (805) 494-0622 • www.sdcsecurity.com • E-mail: [email protected] Any suggestions or comments to this instruction or product are welcome. Please contact us through our website or email [email protected] ELECTRICAL DATA 24VDC @ 700/200mA RED (+) BLK (-) PATENT #8,851,530 Assemble brackets as shown for different size Exit Devices. Attach the Bracket assembly to the existing Device linkage as shown. Once the Bracket is in place, bend out the tabs so the Bracket assembly will slide easily, without falling out or binding. Install the ELR bracket assembly into device extrusion, over the Push Bar support brackets. Apply power to the ELR unit to make it draw the sliding latch bracket back to the open position. Secure in position by tightening the set screws in the ELR assembly. 48" 36" or 42" Slide ELR into back of device and attach to bracket assembly with supplied screw. Bend tabs out Push Bar support bracket Remove End Cap Retrofit Installation Note: 42" or 48" exit devices that have been modified to fit a 36" or smaller opening, may not have the required space to fit the standard E. L. R. assembly. Always verify the distance from the end of the touchpad to the end rail, and if necessary, consult with the factory for appropriate selection. * Visit: sdcsec.com/adamsrite For Installation video