Sealey SG2000W Manuals

2TONNE PORTABLE ADJUSTABLE GANTRY CRANE MODEL NO: SG2000W Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPPORTA TANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PEERSONNAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE. 1. SAFETY  Familiarise yourself with the applications, limitations and hazards peculiar to the portable adjustable gantry crane.  Maintain the portable adjustable gantry crane in good condition.  Replace or repair damaged parts. Use recommended parts only. Unauthorised parts may be dangerous and will invalidate the warranty.  WARNING! This portable adjustable gantry crane is designed for lifting within a garage or workshop environment.  Keep the portable adjustable gantry crane clean for best and safest performance.  Ensure the surface that the portable adjustable gantry crane is to be located is level, even and fi rm and is capable of supporting the imposed loads of the portable adjustable gantry crane. A concrete fl oor is recommended.  DO NOT use the portable adjustable gantry crane on tarmacadam or other soft surfaces as the portable adjustable gantry crane may sink in.  Ensure the crossbeam is level.  Keep children and unauthorised persons away from the working area.  Keep the working area clean and tidy, free from unrelated materials.  Ensure the work area has adequate lighting.  DO NOT exceed the maximum load capacity of the portable adjustable gantry crane. This includes the lifting tackle and block trolley or beam clamp plus the working load.  WARNING! Overloading is dangerous and may cause serious personal injury. To avoid injury, be fully aware of your own and other persons locations when lifting or lowering the load.  Position the portable adjustable gantry crane so that the lifting appliance is directly over the load.  Apply the wheel locks prior to raising the load.  DO NOT attempt to move the portable adjustable gantry crane whilst under load.  DO NOT use a vehicle, winch etc. to tow the portable adjustable gantry crane.  DO NOT allow the load to swing unduly or in an uncontrolled manner.  DO NOT rotate the load unless the centre of gravity will remain under the centre line of the block trolley or beam clamp.  DO NOT allow persons to pass under suspended loads.  DO NOT place ladders or climb on the unrestrained portable adjustable gantry crane.  DO NOT leave suspended loads unattended.  Keep a sound footing and balance, and ensure the fl oor is not slippery and wear non-slip footwear.  DO NOT attempt to alter the crossbeam height whilst under load.  Raise and lower the load with care and ensure the landing area is properly prepared.  DO NOT use the portable adjustable gantry crane to perform a task for which it is not designed.  DO NOT use the portable adjustable gantry crane whilst tired, under the infl uence of drugs, alcohol or intoxicating medication.  When not in use store in a safe, dry childproof location.  WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be applied by the operator. 2. INTRODUCTION Ideal for workshops/garages where level lifting is essential. Fitted with winch in order to easily raise and lower gantry. Four swivel locking castors. Gantry crane is NOT to be moved while loaded. All steel construction with ‘I-beam’ cross member for added strength. Winch assisted height-adjustments (Unladen) from 2400 to 3600mm in 100mm increments. Ideal for maintenance, manufacturing, repairs and other material handling tasks. Quick assembly and disassembly for easy transport within a workplace or from site to site. Lifting tackle not included. 3. SPECIFICATION Model No: ..............................................................SG2000W Gantry width: ............................................................ 2600mm Maximum depth: ...................................................... 1200mm Maximum height: ...................................................... 3600mm Maximum load capacity: .............................................. 2tonne Minimum height: ....................................................... 2400mm SG2000W Issue 1 08/12/21 Original Language Version © Jack Sealey Limited Refer to instructions