Sealey Space Warmer LP13.V3 Manuals

Refer to instructions Hot surface 1.1. GENERAL SAFETY  IMPORTANT: The LP13.V3 is a mobile, propane-fired, unvented, infrared space heater for commercial applications only. It is designed for use with Propane cylinders of between 7kg to 15kg gas capacity. DO NOT use domestically.  WARNING! Use only in well ventilated spaces of more than 15m³ to prevent an accumulation of dangerous combustion gases.  DO NOT operate heater in basements or otherwise below ground level, in high rise flats, bathrooms or bedrooms.  DO NOT operate heater in leisure vehicles such as caravans and autocaravans.  WARNING! Heater will become very hot during use.  WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.  Familiarise yourself with the application and limitations of the heater, as well as the potential hazards.  WARNING! Disconnect the heater from the gas supply before performing any maintenance.  Maintain the heater in good condition (use an authorised service agent).  Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.  WARNING! Keep all guards and holding screws in place, tight and in good working order. The guard on this appliance is to prevent risk of fire or injury from burns and no part of it should be permanently removed. IT DOES NOT GIVE FULL PROTECTION FOR YOUNG CHILDREN OR THE INFIRM. Check regularly for damaged parts. A guard or any other part that is damaged must be repaired or replaced before the heater is next used. Avoid twisting the regulator's flexible tube. The tube should be inspected for damage regularly and replaced if damage is found. Refer to the tube for its specification and length.  Keep gas hose away from heat, oil and sharp edges. Ensure that all connections are secure.  Keep the heater clean for best and safest performance.  Ensure the propane bottle is in a stable upright position before igniting the heater. DO NOT use with the bottle in any position other than upright.  DO NOT use any fuel other than propane.  Ensure there are no flammable or combustible materials within 2 metres of the heater and that nothing, including walls, is less than 500mm from any surface of the heater.  DO NOT use the heater where there are flammable liquids, solids or gases such as paint solvents, etc.   WARNING! NOT to be used for the heating of habitable areas of domestic premises: for use in public buildings, refer to national regulations.   WARNING! DO NOT use in basements or areas below ground level.  DO NOT move the heater when it is operating.  DO NOT use the heater for any purpose other than that for which it is designed.  DO NOT operate the heater if any parts are damaged or missing as this may cause failure and/or personal injury.  DO NOT adjust, or tamper with, the regulator.  DO NOT allow untrained persons to operate the heater.  DO NOT operate the heater when you are tired or under the influence of alcohol, drugs or intoxicating medication.  When not in use disconnect from the gas supply and store in a safe, dry, childproof area.  In the event of a gas leak immediately close the bottle valve, extinguish any flame and then place equipment in a well ventilated area, preferably outdoors, and away from any heat sources (including strong sunlight). Rectify cause of leakage. Ceramic plaque type heater. Mounts on the rim of a propane cylinder. Adjustable output from 10,250 to 15,354Btu/hr. Supplied with 700mm of hose and 37mbar fixed regulator. Fully CE approved. Gas bottle not included. fig.1 IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE. Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. 1. SAFETY 2. INTRODUCTION 3. SPECIFICATION Model No. . . . . . . . . . . . . . . . . . . . . . LP13.V3 Fuel. . . . . . . . . . . . . . . . . . . . . . . Propane Output. . . . . . . . . . . . . . . . . 10,250-15,354Btu/hr Fuel Consumption. . . . . . . . . . . . 0.220-0.330kg/hr SPACE WARMER® PROPANE HEATER 10,250-15,354BTU/HR BOTTLE MOUNTED MODEL NO: LP13.V3 Original Language Version © Jack Sealey Limited LP13.V3 Issue:4 (H,F ERP) -25/06/18 This product is only suitable for well insulated areas or occasional use.