Seametrics iMAG 4700r Manuals

Precision Flow Measurement An ONICON Brand Electrical Quick Start Guide AC Power w/Pulse (A1X/A2X) for: iMAG 4700r / AG3000r 253.872.0284 seametrics.com Wiring Black (Line) White (Neutral) Green (Ground) Black (R) -Remote Pwr: pn10 Red (R) +Remote Pwr: pn9 Green (C1) Pulse+: pn2 White (C1) Pulse-: pn1 Orange (R) Remote B: pn11 Blue (R) Remote A: pn12 Black (Internal): pn14 Red (Internal): pn15 C1 R AC Orange (R) Remote B: pn4 Blue (R) Remote A: pn5 R Black (R) -Remote Pwr: pn2 Red (R) +Remote Pwr: pn1 C1 = power/output cable AC = AC power cable R = remote cable Refer to the Mechanical Quick Start Guide or the complete instruction manual for details on mechanical installation. Remote Meter Remote Display Remote Display: Remove the 3 screws holding the display assembly and remove it from the meter. Remove the 15 pin screw connector from its bag. Install the wires through the cable ports into the 15 pin screw connector in their respective locations. Plug the 15 pin screw connector into its socket. Be sure all pins align properly and that the connector has not slipped to one side. Refer to the complete manual for further details. Remote Meter: Unscrew the user access lid and remove it. Remove the 5 pin screw connector from its socket. Install the wires through the cable port into the 5 pin screw connector in their respective locations. Plug the 5 pin screw connector into its socket. Refer to the complete manual for further details. Plug the backup battery cable into the back of the display assembly. Be sure all pins align properly and that the connector has not slipped to one side. User access lid Front panel—do not open WARNING: Improper sealing of glands or cables will invalidate any warranty. Remove plug & o-ring. Insert cable gland/strain relief. Feed cable through cable gland. CRITICAL! Torque cable gland sealing nut to 22 in-lbs. Clamp cable with strain relief clips. Attach drain wire lug to bracket post. WARNING: BACKUP BATTERIES ARE NOT INTENDED AS A PRIMARY POWER SOURCE