Seneca VISUAL 2E Manuals

Installation and Startup Guide This document covers the installation of VISUAL 2E HMI, for the detailed specifications and operation, please refer to Brochure and EasyBuilder Pro User Manual. Install Environment: NEMA Rating VISUAL 2E HMI is NEMA 4 rated (Indoor Only). Electrical Environment VISUAL 2E has been tested to conform to European CE requirements. This means that the circuitry is designed to resist the effects of electrical noise. This does not guarantee noise immunity in severe cases. Proper wire routing and grounding will insure proper operation. Environmental Considerations (1) Make sure that the displays are installed correctly and that the operating limits are followed. Avoid installing units in environments where severe mechanical vibration or shocks are present. (2) Do not operate the unit in areas subject to explosion hazards due to flammable gases, vapors or dusts. (3) Do not install the unit where acid gas, such as SO2 exists. (4) This device should be mounted in the vertical position and for use on the flat surface enclosure. (5) Conform to UL508 (ISBN 0-7629-0404-6) machine safety for use in Pollution Degree 2 Environment. Unpacking the Unit Unpack and check the delivery. If damage is found, notify the supplier. Installation Instructions Secure the operator panel in position, using all the fastening holes and the provided brackets and screws. Screw Torque: 2.6 ~ 3.9 lbf.in. (For reaching waterproof effect and preventing the panel from being deformed.) Type A(mm) B(mm) VISUAL 2E 192 138 Power Connections System Settings When HMI is powered up and displays image, click the system setting button. (Default System Password: 111111) It is necessary to connect the HMI to your network through a RJ-45 cable. VISUAL 2E Installation Instruction 1 2 NOTE: Place the operator panel on a stable surface during installation. Dropping it or letting it fall may cause damage. 3 5 4 NOTE: 1. Connect positive DC line to the ‘+’ terminal and the DC ground to the ‘-’ terminal. 2. Please do not connect HMI with PLC and PC simultaneously to prevent potential difference from destroying USB ports of HMI and PC. (A) (B) Cutout (1) Installation Instruction, 2-sided A4 *1 (2) Human Machine Interface *1 (3) Power Connector *1 (4) Brackets & Screws *1 pack (1) (2) (4) (3) Go to the Network tab, you may choose to auto get DHCP IP, or designate your own IP. MI005020-E