Serta Motion Custom II Divided King Manuals

Large C-Clamp Clamp Short Bolt Short Bolt Short Bolt STEP 1 STEP 3 STEP 2 Always use two people when setting up the base. Push and align the head and foot sections together, making sure to align both brackets for each side properly as seen here: See Owner’s Manual for complete operating instructions. PART LIST Before discarding the packing materials- ensure all the parts are accounted for. Some parts may be attached to the base or inside boxes, please inspect carefully. (1) 6mm Hex Wrench (1) 13mm Wrench (4) Cotter Pin (4) Clevis Pin (4) Bushing Once aligned, locate the Large C-Clamps provided and use 1 per side. The large clamp goes on outer edge of base, Secure clamps with provided Long bolts, washers and nuts. Refer to Fig. A (repeat for opposite side) Align Clamp with the holes on the frame as seen in Fig. B. Secure the Clamp to each rail using (3) Short Bolts, washers and nuts. Secure head and foot sections together by fastening halves with (2) Short Bolts, washers and nuts. Divided King Quick Installation Guide Large Clamp Fig. A Fig. B Head Motor Foot Motor (2) Large C-clamp (2) Clamp (4) Long Bolt (8) Short Bolt (12) Washer (12) Nut Unpack head and foot motors from base (head motor is larger of the two). Remove the cotter pin and pull out the clevis pin. Place both ends of the motor into the appropriate bracket and make sure the Green Bushings go outside of the metal mouting bracket (Fig. C). Slide the clevis pin through the bracket and motor. Secure by reinserting cotter pin（Fig.D).