Shunxun SX-EX24 Manuals

120m HDMI Extender over Ethernet with H.264 Support many to many broadcasting and IR control 1. Features 1). Use H.264 as compression method 2). Audio and Video transmission Synchronously 3). Support resolution up to 1080p @ 60HZ, data transmission speed is 2.25 Gbps 4). Support LPCM audio format, sample rate is 48KHZ 5). Comply with TCP/IP protocol for transmission, occupy 15M bandwidth on Ethernet. 6). Compliant HDCP 7). Support RS232 pass through 8). Support IR control to the source 9). Support point to point, point to many, many to many broadcasting network configuration 10).Support IGMP switch 11). Support DHCP, switch assign IP for the Transmitter and Receiver automatically 12). With 3 Bit DIP to choose baud rate 13). With 6 Bit DIP to manage group ID 14). Support web browser and DIP to switch the sources 15). With HDMI output for local display on Transmitter 16). One button for recovery 17). DC 5V 2A power supply, power consumption less than 3 W 2. Specifications Operating temperature -5 to +35℃(+23 to +95℉) Operating Humidity Range 5 to 90%RH (No Condensation) Data compression Comply to H.264 Data transmission protocol Comply to TCP / IP Support Video format 480i/480p/576i/576p/720p/1080i/1080p@60HZ Support Audio format LPCM, Audio sampling rate 48KHZ Bandwidth required 15 Mb HDCP Compliant HDCP 1.3 IR Support IR control, IR frequency 20 ~ 60 KHZ RS232 Baud rate Default 2400 HZ, total 8 kinds optional Switch request Support IGMP, support DHCP Group ID Group 00 ~ group 63 TX default IP 192.168.1.11 RX default IP 192.168.1.12 Power supply DC 5V 2A Power consumption Max 3 watt Dimension 120.2x78.6x29 mm Weight 3. Packing content 1x Transmitter 1x Receiver 1x IR-TX 1x IR-RX 1x Manual 2x Power adapter 4. Panel description 1). TX 1) IR-TX 2) CAT5e/6 output 3) HDMI input 4) HDMI output for local display 5) Red indicator of power input (light up always) 6) Green indicator of data status (blinking) 7) DC 5V 2A power input 8) RS232 female 9) 3 Bit DIP for baud rate 10) 6 Bit DIP for group ID 11) reset button 2). RX 1) IR-RX 2) CAT5e/6 input 3) HDMI output 4) Red indicator of power input (light up always) 5) Green indicator of data status (blinking) 6) DC 5V 2A input 7) RS232 male 8) 3Bit DIP for baud rate 9) 6 Bit DIP for group ID 10) reset button 5. Connection and Operation 1). Preparing TX and RX When doing point to point, no need to configure TX and RX, the following steps can be bypassed. when doing point to many and many to many, please make sure every TX and RX has unique IP and MAC address, every TX has unique group ID (DIP switch). Our this over IP Extender has been assigned unique MAC address for every TX and RX when it goes out of factory, so you don’t have to set the MAC for the units. If you are using a Switch that supports DHCP, please enable DHCP so that the Switch will assign an unique IP for TX and RX, and you don’t need to change the IP for the units manually.