Simplicity 204 Manuals

10” HEAVY DUTY PLOW NOTE: REPOSITION BEAM END TO THESE HOLES, WHE USING PLOW WITH 2-WHEEL TRACTORS. ,~fgM ’ the plow is used Hrith the “725”, move the Beam End to the center of the Plow Beam Assembly after moving the Spacer(“A”) to outside of Beam Assem- b/y, o p p o s i t e o f S p a c e r “B” MODEL 725 RIDING TRACTOR LANDLORD RIDING TRACTOR ASSEMBLY AND ADJUSTMENT ( REQUIRES #203 HITCH ADAPTER ) 1. Remove varnish from moldboard and share, using a good grade of varnish remover. (Keep greased when not in use. ) CAUTION: Be sure that the rolling, coulter is out of the ground when the tractor is in reverse gear. 2. Bolt standard ( 1 ) to plow bottom ( 2 ) . 3. Bolt beam ( 3 ) to standard at ( 4 ) . Lock with jam nut so that beam is free to swing on standard. 4. Attach depth regulating yoke rod assembly ( 5 ). Pin and cotter pin. 6. Attach the lift pin and chain assembly ( 9 ) to the beam at ( 8 ) by means of the pin and spring clip pro- vided. The hitch clevis adapter ( 10 ) is then attach- ed to the tractor hitch by means of the pivot pin. Connect the plow to the hitch adapter with the hitch pin and insert the lift pin ( 9 ) In the tractor rear lift assembly and secure in place with a pin and s,pring clip. 5 . A t t a c h r o l l i n g c o u l t e r a s s e m b l y ( 6 ) a n d a d j u s t coulter standard ( 7 ) so that blade runs approximately 7. Wheel weights should be used when operating the l/2” to the left of landslide. Set the rolling coulter 10” Plow. The weights are designed so that as many for best depth depending upon the soil. weights as necessary may be added to the wheels Lie,. in USA S,MPL,C,TY M A N U F A C T U R I N G C O M P A N Y , INC.