Siqura BC820H1 Manuals

Log on To reset the camera to the factory default settings  With the camera powered up, push and hold the reset button for 30 seconds. Siqura BC820H1 & BC820H1-SFP High-definition (HD) box camera with integrated optics Quick Start Guide © Siqura B.V. 2015 Version 2.1 (121904) BC820H1 QSG (MW10) Power up / Connect to network (SFP) Unpack Install Install Siqura Device Manager (optional) www.siqura.com www.tkhsecurity-usa.com Power up / Connect to network (RJ-45) Figure 1 Package contents Determine where you are going to install the camera.  Use the Siqura WM04 Wall Bracket sold separately for BC series cameras (figure 2).  Make sure that the provided surface has sufficient strength to support the camera.  If using Power over Ethernet (PoE), check that there is adequate access to an IEEE 802.3AF Power Sourcing Equipment (PSE) enabled network Figure 2 The BC820H1 screws onto a mounted wall bracket To power the BC820H1 with PoE  Attach the RJ-45 connector to an appropriate PoE network switch.  Use Cat 5 Ethernet cable less than 100 m in length. Connect to hub/switch with straight- through; direct to a PC with crossover. Figure 3 BC820H1 rear board connectors Figure 4 SFP connector on BC820H1-SFP rear board To power the camera with AC 24 V / DC 12 V  Connect to the DC/AC power source as indicated by the labeling of the terminal block. Table 1 AC 24 V / DC 12 V connection assignments Note: Subject to modification. Actual product and accessories may differ in appearance. Indicator LEDs  RJ-45 connector LEDs: Green indicates a good network connection; orange verifies network activity.  Green power LED signifies a good power connection. To power the camera with AC 24 V / DC 12 V  Connect to the DC/AC power source as indicated by the labeling of the terminal block. Table 1 AC 24 V / DC 12 V connection assignments To connect the camera to the network  Slide the XSNet™ SFP modular optical transceiver into the SFP connector (labelled NETWORK) on the rear board of the camera. You can access the settings of the camera via its webpages. Use Internet Explorer 6.x or higher, Chrome, Firefox or Safari to browse the webpages. To open communication with the BC820H1(-SFP) 1. Make an IP connection between the camera and the PC. To achieve initial access, the network adapter of the PC must be set to the same subnet as the camera. The factory-set IP address is printed on a label located on the bottom of the camera. 2. Type the IP address of the camera in the address bar of your web browser (figure 5), and then click ENTER. 3. Enter the default user name (Admin) and password (1234). Note that the user name is case sensitive. 4. When prompted about an ActiveX control installation, click Allow. This installs Siqura Viewer, an add-on required to view camera images in the webpages. Make sure that ActiveX controls are enabled in your web browser. For more information, see the User Manual. Figure 5 Enter the IP address of the camera into the address bar of your browser Figure 6 Install Siqura Device Manager from Siqura Product CD + AC 24 V: Power-1 DC 12 V Power AC 24 V: Earth GND DC 12 V Reserved - AC 24 V: Power-2 DC 12 V GND To reset the camera to the factory default settings  With the camera powered up, push and hold the reset button for 30 seconds. + AC 24 V: Power-1 DC 12 V Power AC 24 V: Earth GND DC 12 V Reserved - AC 24 V: Power-2 DC 12 V GND