Sirius Satellite Radio Streamer GTR Manuals

SIR-GTRV1 Custom Vehicle Installation Kit Installation Guide Streamer GTR SIR-GTRV1 Vehicle Kit Installation Guide 2 Box Contents: When you unpack your SIR-GTRV1 Custom Vehicle Installation Kit, it should include everything as shown below: In-Dash Mount DC Power Cable Audio Cable FM Relay Switch If anything is missing or damaged, or if your SIR-GTRV1 fails to operate, notify your Streamer GTR dealer immediately. It is recommended that you keep the original packaging in case you need to ship your SIR-GTRV1 in the future. Streamer GTR SIR-GTRV1 Vehicle Kit Installation Guide 3 Safety Precautions Warning Take the following precautions to prevent traffic accidents and avoid personal injury: • Installation must be performed according to this installation guide. Brix Labs is not responsible for issues arising from installations not performed according to the procedures in this guide. • Do not install the Receiver where it may obstruct your view through the windshield or your vehicle’s indicator displays. • Do not install the Receiver where it may hinder the function of safety devices such as an airbag. Doing so may prevent the airbag from functioning properly in the event of an accident. • The installation and use suggestions contained in this manual are subject to any restrictions or limitations that may be imposed by applicable law. The purchaser should check applicable law for any restrictions or limitations before installing and/or operating this Receiver. Caution Take the following precautions to keep the Receiver in proper working order: • Be sure the Receiver is connected to a 12V DC power source with a negative ground connection. • Do not install the Receiver where it will be exposed to high levels of humidity, moisture, or dust. • When replacing the fuse, use only a new fuse with the proper rating. Using a fuse with the wrong rating could potentially cause damage to the Receiver in the event of a short circuit. • Failure to follow these safety precautions may result in a serious accident. ! ! Streamer GTR SIR-GTRV1 Vehicle Kit Installation Guide 4 Installing the SIR-GTRV1 Custom Vehicle Installation Kit Professional installation of this product is recommended by Brix Labs. There are two choices for mounting the Receiver: • Suction cup mount • In-dashboard mount The instructions for mounting the suction cup mount are found in the SIR-GTRC1 Streamer GTR user guide. The instructions for mounting the antenna are also found in the SIR-GTRC1 Streamer GTR user guide. Mounting the Receiver: In-Dashboard Mount The in-dash mount may be used in vehicles which provide an opening in the dashboard for this purpose. Place the in-dash mount in the dashboard opening and snap it into place by gently pushing it into the opening on the four corners. Before placing the Receiver into the in-dash mount, the wiring to the Receiver should be installed. Refer to the wiring diagram before proceeding with the remainder of the Receiver installation. The wiring should be routed so that the wires meet the Receiver at the left side for easy attachment to the Receiver. When the wiring has been connected to the Receiver, it may be positioned into the in-dash mount. Line the Receiver up with the in-dash mount and slide the left side of the Receiver into the in- dash mount, making sure the wires connected to the Receiver push behind the in-dash mount at the