Sirius XM RAdio MIRGE Manuals

1 5 2 6 3 7 4 8 Vehicle Dock 19 ANT IN AUDIO OUT DC IN Interoperable Vehicle Antenna 3 Snap the mount onto the vent. To remove, push the mount into the vent, then lift up. Install the Adhesive Mount CAUTION: The adhesive used with the adhesive mount may make it difficult to remove. Do not install this mount on leather surfaces and make sure the air temperature is at least 60°F (15°C). 1 Locate a flat surface for the mount. Make sure there is ample room for the vehicle dock and radio when installed. 2 Clean the surface with the alcohol pad and let it dry thoroughly. 3 Peel off the adhesive liner. Position, press, and hold the adhesive mount in place for 30 seconds. IMPORTANT: Let the adhesive dry for 2 - 3 hours before attaching the vehicle dock and radio to the mount. For best results let dry for 24 hours. Vehicle Installation NOTE: Do it yourself with the step-by-step instructions below if your vehicle has a cassette player or audio input. If your vehicle does not have a cassette player or audio input, professional installation is strongly recommended. If your vehicle requires professional installation you will need to use either the XM SureConnect (sold separately) or the XM FM Direct Adapter (sold separately). Step 1: The Big Decision. Pick a spot for your radio. Vent or Dashboard? You can use either the vent mount or the adhesive mount for your radio depending on your particular situation. Install the Vent Mount 1 Locate a vent with horizontal slats sturdy enough to hold your vehicle dock and radio. 2 Adjust the clamps to fit your vent. Antenna placement options for other vehicles. • Pickup Truck - Above front windshield, on the roof toward front of cab. Centered between right and left sides. • Convertible - On trunk lid, at least 3” from seam. Centered between right and left sides. 2 Hide the wires inside. The best place to hide your antenna wire depends on your vehicle. It’s usually easiest to run the wire from the rear of the vehicle to the front toward the radio by routing the cable along the interior trim where it meets the carpet, by gently pushing it behind the edges of the trim. Then bring the cable out from the trim and route it under the carpet to the dashboard or console. Plug the cable into the radio and coil any extra wires under the carpet or floor mat. TIP! Always be careful to include enough slack in your cable to accommodate open doors or trunk lids. Use things typically found around the home, like electrical tape or twist ties, to secure cables in areas so that hinges do not pinch the cable. Hide any excess cable in the trim. WARNINGS: When using this product it is always important to keep your eyes on the road and hands on the wheel. Not doing so could result in personal injury, death and/or damage to your SIRIUS XM Radio, accessories and /or to your vehicle or other property. The radio should be placed in your vehicle where it will not interfere with the function of safety features, e.g., deployment of airbags. Failure to correctly place radio may result in injury to you or others if the unit becomes detached during an accident and/or obstructs the deployment of an airbag. What’s in the Box? 8 5 2 7 4 1 9 6 3 mute info menu display 0 jump fav + Radio Remote Control Alcohol Pad Vehicle Power Adapter Step 3: Connect Your Radio. Almost there! 1 Plug the Antenna into the vehicle dock’s ANT IN connection. 2 Plug the Power Adapter into the vehicle dock’s DC IN connection. 3 Plug one of the audio adapters into the vehicle dock’s AUDIO OUT connection. • Use the Aux In Cable if your vehicle has an audio input jack. • Use the Cassette Adapter if your vehicle has a built-in cassette player. 4 Insert the dock into the vent or adhesive mount. 5 Insert your radio into the dock. NOTE: If your vehicle is not equipped with a cassette player or an audio input, you will need to use either the XM SureConnect (sold separately) or the FM Direct Adapter (sold separately). A professional installation is strongly recommended if you choose to use this method. Professional installation can help improve your radio’s reception and significantly reduce the visibility of wires. To learn more, go to www.sirius.com/mirge. • XM SureConnect (sold separately): You can listen to your radio through your vehicle’s stereo by using the XM SureConnect. Simply find an unused FM frequency on the stereo and set your radio to transmit on that same frequency. Refer to Set the FM Frequency page in your user guide for more information. • XM FM Direct Adapter (sold separately): This option directly connects the radio to your vehicle’s audio system and antenna. Interoperable Vehicle Antenna Vehicle Power Adapter Cassette Adapter Vehicle Dock Aux In Cable —OR— Cassette Adapter Vent Mount ! ! ! Dash Vent Dash Vent 4 Turn the swivel to accommodate the vehicle dock and radio. Adjust the tension via the center screw. To remove, carefully lift the adhesive pad with your fingers or a spoon. Warming the pad with a hair dryer for several minutes will help soften the adhesive. Step 2: Mount the Interoperable Vehicle Antenna. You’ll be glad you did this right. YOU MUST USE THE INCLUDED INTEROPERABLE ANTENNA WITH THIS RADIO 1 Place the antenna outside. Leave at least 3” of metal around the antenna. Use the rubber tail cover to hide and protect the exposed wire. Feed the wire under the rubber molding around the back windshield, into the seal around the trunk. Route the cable along trunk wall and into the interior cabin from there. Magnet You can adjust this screw to adjust the tension of the mount with a screwdriver. ! ! ! Aux In Cable Adhesive Mount SUV Sedan Vent Mount Adhesive Mount Activate Before you can listen to any of the great channels, you must first activate your radio. NOTE! Make sure your radio is in SIRIUS mode by pressing the SAT button. See page 26 in the user guide for more information. 1 Make sure your radio is properly installed and receiving the SIRIUS signal so that you can hear the audio on SIRIUS Channel 184. 2 Make a note of your radio’s ID number. You can find it: • On Channel 0 on either SIRIUS or XM • On the rear package label • On the label on the back of your radio 3 Activate your service: • Online: Go to www.sirius.com/mirge OR • By phone: call 1-888-539-SIRIUS (1-888-539-7474) 4 Depending on which Satellite Radio services you activated, channels will become available about 10 to 15 minutes after activation — although it may take up to an hour. Your radio must remain ON until activated. ! ! ! Step 4: Turn on Your Radio and Test for Sound. 1 Turn on your vehicle’s radio. 2 Insert the cassette adapter or AUX In Cable. NOTE: If you are using the XM SureConnect or the XM FM Direct adapter, refer to Turn the FM modulator ON/OFF on page 54 of the user guide for more information. 3 Turn ON your radio. NOTE: You may experience a brief delay while your radio powers up. If you press the power button during this time, you will see a “Please Wait” message. Antenna Cover/Tail SIR10492 SportsterRCi_GSG_101708.indd 1 10/17/08 4:56:09 PM

Compact Sound System TM