Skytech Smart Batt III Manuals

REV. 8-7-17 Page 1 Skytech: Smart Batt III Model: Smart Batt III INSTALLATION AND OPERATION INSTRUCTIONS IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT ATTEMPT TO INSTALL OR OPERATE INTRODUCTION This remote control system was developed to provide safe, reliable, user-friendly operation for gas heating appliances. This is a dry contact, thermostat controlled system with built-in timer that can be operated from the transmitter. The transmitter operates on (2) AAA 1.5V batteries that are included. Install the AAA batteries supplied with the unit into the battery compartment. It is recommended that ALKALINE batteries always be used for this product. Be sure the batteries are installed with the (+) and (-) ends facing the correct direction. If the transmitter does not illuminate when you press any buttons, or you see nothing on the LCD screen, check the position of the batteries. TRANSMITTER MODE TIME TIMER SET DOWN UP + + - - LIQUID CRYSTAL DISPLAY - LCD ON OFF THERMO X ROOM SET AM PM TIMER FLAME E E 1 2 3 4 5 6 7 8 1. Low Battery Indicator - Battery power is low, replace batteries within two weeks. 2. Timer - Time remaining before the system shuts off. 3. Mode - Indicates whether the system is ON, OFF, or in THERMO mode. 4. Set - Indicates the desired SET temperature when in THERMO mode. 5. Flame - Indicates appliance is on. 6. Clock - Indicates current time. 7. Room - Indicates current ROOM temperature. 8. ºF - Indicates degrees Fahrenheit (ºC indicates degrees Celsius). MODE FUNCTION To select an operational mode, press the MODE button on the transmitter. ON - Turns the appliance ON, the flame icon will appear on the LCD screen. THERMO - Remote is in THERMO mode. OFF - Turns the appliance OFF, the flame will disappear from the LCD screen. The factory setting for temperature is degrees Fahrenheit (ºF). To change this setting to degrees Celsius (ºC): • Remove battery cover on the back of the transmitter and locate the setting button in the top center of the battery compartment. • Push the button once to enter temperature scale setting mode. • Use the up and down buttons to switch between the ºF and ºC. • Push the setting button again once again to set the displayed temperature scale. • Repeat this procedure to switch back to ºF. SETTING ºFAHRENHEIT / ºCELSIUS SCALE + - SETTING BUTTON