SMA 800-3PH300 Manuals

Page 1 General Information Thank you for purchasing this product. The purpose of this manual is to assist you in operating and maintaining your 3-Point Sprayer. Retain a copy of your receipt for your unit, as it will be required to validate any warranty service Products are warranted against manufacturer or workmanship defects for one year from date of purchase for home owner usage and 90 days for commercial usage. For technical assistance, visit our website @ www.fimcoindustries.com or call: TOLL FREE @ 1-800-831-0027 Our Technical Support Representatives will be happy to help you. To obtain prompt, efficient service, always remember to give the following information…  Correct Part Description and/or part number  Model #/Serial # of your sprayer Part descriptions and numbers can be obtained from the illustrated parts list section(s) of this manual. OWNER’S MANUAL Category I or II Model: 800-3PH300 (5301642) (300 Gallon 3-Point Sprayer w/Handgun) (Boom-Ready) Assembly Instructions 1. Install the tee valve sub-assembly to the 3-point carrier valve mount and position as shown in the exploded view. 2. Slip the 1/2” bypass hose (from the relief valve) over the fitting on the bottom of the tank. Slide the hose clamp to the end of the hose and secure. 3. Find the 1” x 36” pump feeder hose. Using a good quality thread sealant, carefully thread the 1” fitting into the strainer and the 3/4” fitting into the inlet side of the pump. Slip the hose all the way onto the fittings and secure with the hose clamps. 4. Attach the 3/4” hose coming off the valve assembly to the out- put side of the pump by threading the 3/4” fitting into the pump and securing with the hose clamp. Remember to use sealant. 5. The roller pump is NOT included with the assembly. Attach the adapter, the torque chain and S-hook to a pump as needed. It is intended for your pump to be mounted directly to the tractor PTO. The torque chain needs to be secured to the tractor to keep your pump from spinning. 6. Wrap the handgun hose around the hose hangers which are attached to the tank straps. 7. Using sealant thread the gauge into the top of the tee valve assembly. 8. This unit is ready for a boom to be attached to the upright mounting angles with u-bolts. One, two or three boom feeder hoses may be used by removing the unused hose and fitting from the TeeValve and replacing it with a pipe plug (supplied). Attach the boom feeder hoses to the boom and secure with hose clamps. Jonesboro, AR 72401 Phone: 870-935-3291 Fax: 870-935-5651 5004995 (01/19)