Smartenit ZBPLM Manuals

2014 Compacta International, Ltd. - Rev. 2/2019 ZBPLM and Smartenit are trademarks of Compacta International, Ltd. ZigBee is a registered trademark of the ZigBee Alliance, INSTEON is a registered trademark of SmartLabs, Inc., and X10 is a registered trademark of X10. DB9 Serial Port USB Port ZBPLM is a multi-protocol interface that allows communication from a computer or any device to control and monitor ZigBee, INSTEON and X10 home automation devices. The ZBPLM also enables the setup and interoperability between ZigBee Home Automation (HA) devices without the requirement of a computer. With the seamless integration of these three leading home and building automation protocols, the limitations of what you can accomplish start to disappear! Program Button Status LED Note: ZBPLM must be installed indoors Now with external antenna* for increased range (not shown) * Serial version only * Serial version only (949) 429-3303 Technical Support Smartenit.com Quick Start Guide - ZBPLM TM Product Brief Installation Home Automation Interface Interface Setup 1. Using with Serial API: • This method is typically for developers. ZBPLM implements the Smartenit Serial API, which is documented here: http://docs.smartenit.com/software/zbpcid_api.pdf 2. Using with Smartenit Gateways/Hubs: • Follow installation process mentioned above and then attach the other end of USB cable to Gateway/Hub 3. Using with IoT8-Z as an Insteon bridge. Follow steps below and then refer to the IoT8-Z quick start guide • Factory reset ZBPLM: Press button while reconnecting to power and continue to hold button for 4 secs • Start Network: Tap the set button 11 times in quick succession. LED should stop blinking and stay solid. • Discover zigbee device: Press and hold the Set button for 7 secs, LED should start to blink slowly 1. Connect ZBPLM to Computer or Gateway • Using cable provided (RJ-45 to DB9 or USB), connect ZBPLM to computer/gateway. (If USB version, connect USB cable after completing step 3 below) 2. Connect external antenna and point upwards * 3. Connect ZBPLM to 120V AC power • Press and hold the Program Button while plugging into power to ensure ZBPLM is reset to factory defaults. • After a couple seconds, the LED will begin to blink, indicating that ZBPLM is reset. 2014 Compacta International, Ltd. - Rev. 2/2019 ZBPLM and Smartenit are trademarks of Compacta International, Ltd. ZigBee is a registered trademark of the ZigBee Alliance, INSTEON is a registered trademark of SmartLabs, Inc., and X10 is a registered trademark of X10. (949) 429-3303 Technical Support Smartenit.com - 115,200 Baud - 8 data bits - No parity - 1 stop bit RS-232 Serial Communications Addition Information The INSTEON ID for your ZBPLM is located on the back of the unit. It will be six digits long separated by periods. (Example - 05.BE.2F ) The MAC ID for your ZBPLM is also located on the back of the unit. It will be 16 digits long. (Example - 00158D00000E682A ) ID Numbers ZBPLM Connector Pin 1 - RS-232 to PC Pin 2 (Rx) Pin 2 - Unregulated +12VDC Output, Maximum 300mA Pin 3 - Not Used Pin 4 - Ground Pin 5 - Not Used Pin 6 - Not Used Pin 7 - Ground Pin 8 - RS-232 from PC Pin 3 (Tx) RJ-45Connector Specifications Monitor and Control Anything from Anywhere. See our products in action at http://video.Smartenit.com