Snapper LT Series Manuals
1 pdf manual(s) Snapper LT Series for free download (Document Types: Setup instructions)
Snapper LT Series Setup instructions [PDF] (4 pages)
- Identifier: id-380146
- Brand: Snapper
- Device: LT Series Lawn Mower
- Type: PDF
- Key Aspects: Package Contents and Accessories List, Information on Regular Maintenance, Regulatory Compliance and Standards
- UPD Date: 08.06.2026
- Source File: 356776.pdf
- Pages: 4
- Description: Device maintenance guide for the Snapper LT Series.
Pages Preview:
Document Preview & Text Transcription (Main Page)
Click to expand and read text
1 DEALER SET-UP INSTRUCTIONS & PRE-SALE CHECKLIST for EUROPEAN SNAPPER LT SERIES TRACTORS INTRODUCTION: Snapper LT (One Piece Frame) Tractors are shipped with the steering wheel and seat cushions removed. The following steps are required for set-up. Complete all items on the Dealer Pre-Sale Checklist at time of purchase. NOTE: Figure 1 shows the seat assembled to the seat pedestal assembly. Some models are shipped with the seat loose and will require installation. FIGURE 1 ACTIVATE BATTERY The battery is not installed and is shipped dry. Allow sufficient time for charging and installing the battery before operating the tractor. Pay close attention to the precautionary statements on the battery and in these instructions. Electrolyte must be purchased separately from your local dealer or retailer. You will also need an automotive type battery charger to activate the battery for use. STEP 1: SEAT/PEDESTAL ASEMBLY REMOVAL 1. Remove the seat/pedestal assembly by removing the two seat knobs that secure it to rear fender. See Figure 1. Note: The seat switch wires are still connected, so be careful. 2. Move the seat/pedestal assembly forward and out of the way. STEP 2: ACTIVATING AND CHARGING BATTERY 1. Remove battery from carton. 2. Place battery in a well ventilated area on a level surface. INSTRUCTION No. 7-2348 (I.R. 6/13/02) WARNING The electrolyte (acid) produces a highly explosive gas. Keep all sparks, flame and fire away from area when charging battery or when handling electrolyte or battery. Electrolyte (acid) is a highly corrosive liquid. Wear eye protection. Wash affected areas immediately after having eye or skin contact with electrolyte (acid). Flush with clear water and neutralize with baking soda. DO NOT OVER FILL! 3. Remove battery cell caps. Fill cells as required with electrolyte (purchased separately) to proper level. Fill to 3/16” above cell plates. Filling battery with electrolyte will bring the battery to 80% charged state. Note: 3/16” above cell plates is the recommended level. DO NOT place anything in battery other than specified electrolyte. (OVER) SEAT SEAT/PEDESTAL ASSEMBLY BATTERY SEAT KNOB
