Sonance SB46M Manuals

I N S T A L L A T I O N M A N U A L S O N A N C E S O U N D B A R S S B 4 6 M A N D S B 4 6 L Box Contents Sonance Soundbar Box contains: (1) Soundbar, (2) Flat Soundbar connectors, (2) Display attachment rails, (2) Recessed Soundbar connectors, (1) Key hole wall mount template, (2) Key hole wall mounts, (2) Display spacers and (2) Black opaque strips. The Hardware Pack contains: A. (4) M8 10mm screws for display attachment rails, B. (4) M8 14mm screws for flat Soundbar connector, C. (4) M8 23mm short screws for recessed Soundbar connector, D. (4) M8 38mm long screws for recessed Soundbar connector, E. (4) M6 25mm screws, F. (4) M8 25mm screws, G. (8) M8 nuts, H. (8) M6 washers, I. (8) M8 washers and J. (4) Rubber feet. Introduction Thank you for purchasing the Sonance Soundbar SB46 M or SB46 L. When properly installed your new Soundbar will give you years of entertainment pleasure. The Sonance SB46 M & SB46 L Soundbar is a high performance Left, Center, & Right 3-way speaker system housed in a sealed aircraft grade aluminum enclosure. The SB46 M will align with displays from 50” to 65” diagonal. The SB46 L will align with displays from 70” to 80” diagonal. 1 A. x 4 D. x 4 G. x 8 B. x 4 E. x 4 H. x 8 I. x 8 J. x 4 C. x 4 F. x 4 (1) Soundbar (2) Display attachment rails (2) Flat Soundbar connectors (2) Recessed Soundbar connectors (1) Key hole wall mount template (2) Key hole wall mounts (2) Display spacers (2) Black opaque strips Before any installation carefully plan where wiring will pass through walls. Perform an obstruction survey using a stud finder to be certain there are no studs, conduit, pipes, heating ducts, pocket doors or air returns in the wall cavity. If you are unsure about obstructions, drill a small hole near where the Soundbar wire terminals will be located and insert a coat hanger wire into the hole to feel around for possible obstructions. Run three sets of speaker wires: Left channel, Center channel, Right channel as well as the necessary video cable from the amplifier to the display location. Whenever possible leave extra wire to make it easy to connect the wire to the Soundbar spring terminals prior to hanging the display. Extra wire can then be pushed back into the wall. NOTE: CONSULT LOCAL BUILDING CODES BEFORE RUNNING SPEAKER AND ELECTRICAL WIRES THROUGH WALLS. Wall Mount Installations Verify the wall mount will support the combined weight of the display and Soundbar. SB46 M weighs 24 lbs. (10.88 kg) installed. Suitable for displays 50” to 65” (1270mm to 1651mm). SB46 L weighs 29 lbs. (13.15 kg) installed. Suitable for displays 70” to 80” (1778mm to 2032mm). NOTE: CAREFULLY FOLLOW INSTALLATION DIRECTIONS FOR THE THIRD PARTY DISPLAY WALL MOUNT.