Sony RM-SC200 - S Link Remote Manuals

1 RM-SC200.3-858-330-11.E 3-858-330-11(1) Remote Commander Operating Instructions © 1996 by Sony Corporation RM-SC200 2 RM-SC200.3-858-330-11.E WARNING This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: •Reorient or relocate the receiving antenna. •Increase the separation between the equipment and receiver. •Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. •Consult the dealer or an experienced radio/TV technician for help. You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. Installing the Batteries Slide open the battery compartment and install two size AA (R6) batteries matching the ] and } on the batteries with the ] and } on the battery compartment. 3 RM-SC200.3-858-330-11.E Notes on the batteries •Under normal conditions, batteries will last up to three months. If the Remote Commander does not operate properly, the batteries might be worn out. When replacing batteries, replace both of them with new ones. •Do not mix old batteries with new ones or mix different types of batteries together. •If you take a long time replacing the batteries, or press any button during the battery replacement, the setting may be erased. •If the electrolyte inside the battery should leak, wipe the contaminated area of the battery compartment with a cloth and replace the old batteries with new ones. To prevent the electrolyte from leaking, remove the batteries when you plan to not use the Commander for a long period of time. 4 RM-SC200.3-858-330-11.E About This Manual This Remote Commander is designed for operating the Sony S-Link compatible audio/video components. The recommended system connection diagram This manual assumes that you connect the system as shown in the figure below. Video out A/V signal RF in Antenna TV out S-Link/ CTRL S in (See the note on page 6.) (See the note on page 6.) S-Link/ CTRL S out S-Link/ CTRL S out S-Link/ CTRL S out TV in monitor out Video in A/V signal A/V s A Video signal Tape monitor in Tape record out MD audio in MD Record out CD audio in Cable box DBS tuner TV Receiver Video in Video in Audio signal Audio signal S-Link/CTRL A1 Audio signal Audio signal Audio signal Video in Antenna S-Link/ CTRL S in S-Link/ CTRL S out