Sony XR-C5100 Manuals

MICROFILM SERVICE MANUAL US Model Canadian Model Model Name Using Similar Mechanism XR-C5100 Tape Transport Mechanism Type MG-25F-136 SPECIFICATIONS XR-4890 Photo: XR-4890 FM/AM CASSETTE CAR STEREO – Continued on next page –

3-861-688-11 (1) FM/AM Cassette Car Stereo Installation/Connections Installation/Connexions Sony Corporation  1998 Printed in Thailand XR-C5100 XR-4800 Parts for Installation and Connections The numbers in the list correspond to those in the instructions. 1 6 × 1 2 × 1 × 1 4 Pièces de montage et de raccordment Les numéros de la liste correspondent à ceux des instructions. Installation Precautions •Do not tamper with the four holes on the upper surface of the unit. They are used for tuner adjustments to be made only by service technicians. •Choose the mounting location carefully so the unit will not interfere with driving. •Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration. •Use only the supplied mounting hardware for safe and secure installation. Mounting angle adjustment Adjust the mounting angle to less than 20°. Installation Précautions •Ne pas toucher les quatre orifices sur le panneau supérieur de l’appareil. Ils servent aux réglages du tuner qui ne doivent être effectués que par un technicien. •Choisir soigneusement l’emplacement de l’installation, pour que l’appareil ne gêne pas la conduite. •Eviter d’installer l’appareil dans un endroit exposé à des températures élevées, comme en plein soleil ou à proximité d’une bouche d’air chaud, ou à de la poussière, saleté ou vibrations violentes. Retrait et pose du panneau avant Avant d’installer l’appareil, déposer le panneau avant. Retrait Appuyez sur la touche (RELEASE) pour dégager la façade amovible, puis sortez-la délicatement. Pose Aligner les points A et B, puis pousser l’appareil jusqu’au déclic. To detach Retrait To attach Pose How to Detach and Attach the Front Panel Before installing the unit, detach the front panel. To detach Press (RELEASE) to detach the front panel then gently pull it out. 1 Mounting the Unit in a Japanese Car This unit may not be installed in some makes of cars. In this case, consult your nearest Sony dealer. Installation de l’appareil dans une voiture japonaise Cet appareil ne peut pas être installé dans certaines voitures. Consultez, dans ce cas, votre concessionnaire Sony. 2 TOYOTA (RELEASE) Mounting Example Installation in the dashboard 3 Bend these claws for a tight fit, if necessary. Si nécessaire, plier ces griffes pour assurer une connexion ferme. 2 1 Exemple de montage Installation dans le tableau de bord Dashboard Tableau de bord Fire wall Paroi ignifuge 2 4 3 * To the prevent malfunction, install only with the supplied screws 6. Do not use an electric or impact screwdriver. * Pour éviter tout dysfonctionnement, utilisez uniquement les vis 6 pour le montage. N’utilisez pas de tournevis électrique ou à percussion. NISSAN A B Bracket Support Bracket Support 6* max. size M5 × 8 mm Dimension max. M5 × 8 mm to dashboard/center console au tableau de bord/console centrale 1 Bracket Support Bracket Support to dashboard/center console au tableau de bord/console centrale •Pour garantir un montage sûr, n’utiliser que le matériel fourni. Réglage de l’angle de montage Ajuster l’inclinaison à un angle inférieur à 20°. 182 mm 53 mm 6* max. size M5 × 8 mm Dimension max. M5 × 8 mm 6* max. size M5 × 8 mm Dimension max. M5 × 8 mm 6* max. size M5 × 8 mm Dimension max. M5 × 8 mm × 1 × 5 (incl. 1 reserve) (1 réserves comprises) 7 × 1 8 3 × 1 To attach Align parts A and B, and push the front panel in until it clicks. 5 × 1 First attach 5 to the unit, then insert the unit into 1. Fixez tout d’abord 5 à l’appareil, puis insérez l’appareil dans 1. 1 5 With nippers or similar, cut off the claws on both side of the unit. A l’aide d’une tenaille ou d”un objet similaire, coupez les griffes de chaque côté de l’appareil. Caution Cautionary notice for handling the bracket 1. Handle the bracket carefully to avoid injuring your fingers. Attention Remarque importante pour la manipulation du support 1. Manipulez précautionneusement le support pour éviter de vous blesser aux doigts. The release key 7 is used for dismounting the unit. See the Operating Instructions manual for details. La clé de déverrouillage 7 est nécessaire pour démonter l’appareil. Consulter le mode d’emploi pour plus de détails. Existing parts supplied with your car Pièces existantes fournies avec la voiture Existing parts supplied with your car Pièces existantes fournies avec la voiture

 1998 by Sony Corporation 3-861-687-12 (1) Operating Instructions EN FM/AM Cassette Car Stereo XR-C5100 XR-4800 Owner’s Record The model and serial numbers are located on the bottom of the unit. Record the serial number in the space provided below. Refer to these numbers whenever you call upon your Sony dealer regarding this product. Model No. XR-C5100/4800 Serial No. For installation and connections, see the supplied installation/connections manual.

MICROFILM SERVICE MANUAL US Model Canadian Model E Model XR-C5100 Model Name Using Similar Mechanism XR-4800 Tape Transport Mechanism Type MG-25F-136 AUDIO POWER SPECIFICATIONS (US model) POWER OUTPUT AND TOTAL HARMONIC DISTORTION 17 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 1% total harmonic distortion. Cassette player section Tape track 4-track 2-channel stereo Wow and flutter 0.08% (WRMS) Frequency response 30 – 18,000 Hz Signal-to-noise ratio 58 dB Tuner section FM Tuning range FM tuning interval: 87.5 – 107.9 MHz (US, Canadian model) 50 kHz/200 kHz switchable 87.5 – 108.0 MHz (at 50 kHz step) 87.5 – 107.9 MHz (at 200 kHz step) (E model) Antenna terminal External antenna connector Intermediate frequency 10.7 MHz Usable sensitivity 8 dBf Selectivity 75 dB at 400 kHz Signal-to-noise ratio 65 dB (stereo), 68 dB (mono) Harmonic distortion at 1 kHz 0.5% (stereo), 0.3% (mono) Separation 35 dB at 1 kHz Frequency response 30 – 15,000 Hz Capture ratio 2 dB AM (MW) Tuning range AM tuning interval: 530 – 1,710 kHz (US, Canadian model) MW tuning interval: 9 kHz/10 kHz switchable 531–1,602 kHz (at 9 kHz step) 530 – 1,710 kHz (at 10 kHz step) (E model) Antenna terminal External antenna connector Intermediate frequency 10.71 MHz/450 kHz. Sensitivity 30 µV SW (E model) Tuning range SW tuning interval: SW1: 2,940 – 7,735 kHz SW2: 9,500 – 18,135 kHz (except for 10,140 – 11,575 kHz) Antenna terminal External antenna connector Intermediate frequency 10.71 MHz/450 kHz Sensitivity 50 µV SPECIFICATIONS US, Canadian Model FM/AM CASSETTE CAR STEREO E Model FM/MW/SW CASSETTE CAR STEREO – Continued on next page – www. xiaoyu163. com QQ 376315150 9 9 2 8 9 4 2 9 8 TEL 13942296513 9 9 2 8 9 4 2 9 8 0 5 1 5 1 3 6 7 3 Q Q TEL 13942296513 QQ 376315150 892498299 TEL 13942296513 QQ 376315150 892498299 http://www.xiaoyu163.com http://www.xiaoyu163.com

MICROFILM SERVICE MANUAL US Model Canadian Model E Model XR-C5100 Model Name Using Similar Mechanism XR-4800 Tape Transport Mechanism Type MG-25F-136 AUDIO POWER SPECIFICATIONS (US model) POWER OUTPUT AND TOTAL HARMONIC DISTORTION 17 watts per channel minimum continuous average power into 4 ohms, 4 channels driven from 20 Hz to 20 kHz with no more than 1% total harmonic distortion. Cassette player section Tape track 4-track 2-channel stereo Wow and flutter 0.08% (WRMS) Frequency response 30 – 18,000 Hz Signal-to-noise ratio 58 dB Tuner section FM Tuning range FM tuning interval: 87.5 – 107.9 MHz (US, Canadian model) 50 kHz/200 kHz switchable 87.5 – 108.0 MHz (at 50 kHz step) 87.5 – 107.9 MHz (at 200 kHz step) (E model) Antenna terminal External antenna connector Intermediate frequency 10.7 MHz Usable sensitivity 8 dBf Selectivity 75 dB at 400 kHz Signal-to-noise ratio 65 dB (stereo), 68 dB (mono) Harmonic distortion at 1 kHz 0.5% (stereo), 0.3% (mono) Separation 35 dB at 1 kHz Frequency response 30 – 15,000 Hz Capture ratio 2 dB AM (MW) Tuning range AM tuning interval: 530 – 1,710 kHz (US, Canadian model) MW tuning interval: 9 kHz/10 kHz switchable 531–1,602 kHz (at 9 kHz step) 530 – 1,710 kHz (at 10 kHz step) (E model) Antenna terminal External antenna connector Intermediate frequency 10.71 MHz/450 kHz. Sensitivity 30 µV SW (E model) Tuning range SW tuning interval: SW1: 2,940 – 7,735 kHz SW2: 9,500 – 18,135 kHz (except for 10,140 – 11,575 kHz) Antenna terminal External antenna connector Intermediate frequency 10.71 MHz/450 kHz Sensitivity 50 µV SPECIFICATIONS US, Canadian Model FM/AM CASSETTE CAR STEREO E Model FM/MW/SW CASSETTE CAR STEREO – Continued on next page –