Instruction manual [PDF] (7 pages)
- Brand: SOUNDMASTER
- Model: UR600SW
- Format: PDF
- Key Aspects: Troubleshooting Information, System Limitations and Considerations, Standard Operating Procedures
- Updated: 27.06.2026
- Source File: 2020785.pdf
- Pages: 7
- Description: User instruction booklet for the SOUNDMASTER UR600SW.
Document Preview & Text Transcription
This symbol indicates the presence of dangerous
voltage inside the enclosure, sufficient enough to
cause electric shock.
This symbol indicates the presence of important
operating and maintenance instructions for the
device.
Safety, Environmental and Setup Instructions
•
Use the device in dry indoor environments only.
•
Protect the device from humidity.
•
Do not open the device. RISK OF ELECTRIC SHOCK! Refer opening and servicing to qualified personnel.
•
Connect this device to a properly installed and earthed wall outlet only. Make sure the mains voltage corresponds with
the specifications on the rating plate.
•
Make sure the mains cable stays dry during operation. Do not pinch or damage the mains cable in any way.
•
A damaged mains cable or plug must immediately be replaced by an authorized service center.
•
In case of lightning, immediately disconnect the device from the mains supply.
•
Children should be supervised by parents when using the device.
•
Clean the device with a dry cloth only.
Do NOT use CLEANING AGENTS or ABRASIVE CLOTHS!
•
Do not expose the device to direct sunlight or other heat sources.
•
Install the device at a location with sufficient ventilation in order to prevent heat accumulation.
•
Do not cover the ventilation openings!
•
Install the device at a safe and vibration-free location.
•
Install the device as far away as possible from computers and microwave units; otherwise radio reception may be
disturbed.
•
Do not open or repair the enclosure. It is not safe to do so and will void your warranty. Repairs only by authorized
service/ customer center.
•
Only use mercury and cadmium-free batteries.
•
Used batteries are hazardous waste and NOT to be disposed of with the household waste!!!
Return the batteries to your dealer or to collection points in your community.
•
Keep batteries away from children. Children might swallow batteries.
Contact a physician immediately if a battery was swallowed.
•
Check your batteries regularly to avoid battery leakage.
•
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
•
CAUTION: Danger of explosion if battery is incorrectly replaced
Replace only with the same or equivalent type
ENVIRONMENTAL PROTECTION
Do not dispose of this product with the normal household waste at the end
of its life cycle. Return it to a collection point for the recycling of electrical
and electronic devices. This is indicated by the symbol on the product,
user manual or packaging.
The materials are reusable according to their markings. By reusing, recycling or
other forms of utilization of old devices you make an important contribution to
the protection of our environment.
Please contact your local authorities for details about collection points.
WARNING
Risk of electric shock
Do not open!
Caution: To reduce the risk of electric shock, do not remove the
cover (or back). There are no user serviceable parts inside. Refer
servicing to qualified service personnel.
UR600SW / English Instruction Manual
1
Location of Controls
Main Unit
Front View Rear View
1.
Power / FUNC (function)
/ SNOOZE Button
- Press to turn unit on.
- Press and hold to return unit to standby mode.
- While unit is on, press to select Radio, Bluetooth and
AUX-IN mode.
- Activate the snooze function.
2.
TUN +/- Button
- In radio mode: Tune the radio frequency up/down.
- In Bluetooth mode: Skip tracks Forward / Backward.
3.
VOL +/- Button
- Adjust the output volume level.
4.
SNZ (Snooze) status LED Indicator
5.
SLP (Sleep) status LED Indicator
6.
ALM 2 (Alarm 2) status LED Indicator
7.
ALM 1 (Alarm 1) status LED Indicator
8.
LED Display
9.
PM LED Indicator
- In 12 hour format mode: LED on for PM; LED off for AM.
10.
FM Radio mode LED Indicator
11.
BT (Bluetooth) mode LED Indicator
12.
AUX (Auxiliary Input) mode LED Indicator
13.
CLOCK Button
- Set clock and 12/24 hour format.
14.
SLEEP / DIMMER Button
- Press and hold to set LED display Dim or Bright.
- While the unit is on, press to set the time duration of the
sleep timer.
15.
ALARM / MEM Button
- Set alarm time and select alarm source.
- In radio mode: Enter saving preset radio station mode.
16.
PRESET /
Button
- Press to select preset radio station.
- Bluetooth music Play/Pause function.
17.
EQ Button
- Select preset EQ (Bass/Pop/Rock/Jazz/Classic/Off ).
18.
Speakers
19.
Clock/Memory backup battery compartment
20.
FM Antenna wire
21.
AUX-IN Jack
Connect any compatible portable audio device to this jack
for amplified audio output.
22.
DC-In Jack
Only connects the supplied AC-DC Power Adaptor to this
jack to power the unit.
23.
USB port
DC output for charging mobile phone.
24.
Bass Reflex Opening
This opening should never be blocked otherwise the bass
effect will be reduced.
UR600SW / English Instruction Manual
2
Remote Control
1.
Infrared Transmitter
2.
STANDBY button
- Turn the unit on and off.
3.
SNOOZE button
- Activate the snooze function.
4.
AUX Button
- Press to select AUX-IN mode.
5.
Button
- Bluetooth music Play/Pause function.
6.
/ Button
- In Bluetooth mode: Skip tracks Backward / Forward.
7.
VOLUME + / - Button
- Adjust the output volume level.
8.
MUTE Button
- Mute the volume.
9.
ST. / MONO Button
- Select FM radio stereo/mono receiving mode.
10. EQ Button
- Select preset EQ (Bass / Pop / Rock / Jazz / Classic / Off ).
11. SLEEP
Button
- Select the time duration of the sleep timer.
12. BT. Button
- Press to select Bluetooth mode.
13. RADIO Button
- Press to select FM Radio mode.
14. CH + / - Button
- In radio mode: Select preset station channel.
15. TUN + / - Button
- In radio mode: Tune the radio frequency up/down.
16. CLOCK Button
- Set clock and 12/24 hour format.
17. ALARM / MEM Button
- Set alarm time and select alarm source.
- In radio mode: Enter saving preset radio station mode.
18. DIMMER Button
- Turn LED display bright/dim.
19. Battery Compartment
Installation
Clock setting / Memory battery back-up
A backup battery compartment located at rear of the unit.
(1)
Loose the battery compartment screw.
(2)
Open the clock / Memory battery compartment lid.
(3)
For the first time use: just remove the insulation tag.
For battery replacement: install a DC 3V CR2032 type Lithium battery (with the polarity plus side facing up).
(4)
Close the battery compartment lid.
(5)
Screw tight the compartment lid.
Remote Control
The remote control operates on one CR2025 Lithium battery (included).
To activate the remote control, remove the insulation tag attached in the battery compartment.
Connecting the unit to the AC adaptor power
Plug the AC Adaptor’s DC plug into the DC Jack on the back of unit.
Plug the adaptor into a standard AC mains outlet.
