Spa Electrics ARGON Manuals

INSERT FLAT BLADE SCREWDRIVER INTO NICHE ABOVE TOP 12 O’CLOCK ARROW AND LEVER OFF LIGHT RIM ROTATE LIGHT ASSEMBLY COUNTER-CLOCKWISE SO THE ARROW ON THE LIGHT ASSEMBLY IS AT 10 O’CLOCK AND THEN PULL OUT THE LIGHT ASSEMBLY FROM NICHE LIGHT REMOVAL PRODUCT SUPPORT & INFORMATION For the most up to date installation information and contact information for assistance in your region, please visit www.spaelectrics.com COPYRIGHT 2020 SPA ELECTRICS PTY. LTD. ALL RIGHTS RESERVED US 20201116 www.spaelectrics.com Toll Free: 1800 708 5545 Email: [email protected] WINTERIZATION INSTRUCTIONS 1: PUSH AND LEVER OFF LIGHT RIM WITH FLAT BLADE 2: ROTATE AND PULL OUT LIGHT ASSEMBLY STORAGE ENSURE LIGHT ASSEMBLY AND LIGHT RIM IS SAFELY STORED FOR NEXT SEASON USE UNSCREW PLUG COLLAR COUNTER-CLOCKWISE UNTIL IT IS FREE SPINNING DISCONNECT LIGHT ASSEMBLY FROM PLUG BY PULLING APART 3: REMOVE PLUG FROM LIGHT 4: DISCONNECT THE TERMINALS • Flat-blade screw driver • Lights must be removed from pool wall and cable disconnected via plug connection & stored in a safe place. • Winterization Cover must be fitted to Plug Top prior to reinstalling into niche for winter. • Unless niche/conduit connection is adequately sealed (i.e. via included cable gland components), pool water level must be drained down 12” below the lowest light(s) position in pool wall. • All conduits should be checked for accumulated water and drained if required. • Follow instructions OR consult your local pool professional for complete pool winterization process. • All installation steps should be carried out with manual tools only. The use of power tools during installation is not recommended as these devices can cause faults and damage to light components. • Images are for illustrative purposes only. Appearances of parts and assemblies may vary from the illustrations. TOOLS REQUIRED IMPORTANT NOTES PRODUCT SUPPORT & INFORMATION For the most up to date installation information and contact information for assistance in your region, please visit www.spaelectrics.com COPYRIGHT 2020 SPA ELECTRICS PTY. LTD. ALL RIGHTS RESERVED US 20201116 www.spaelectrics.com Toll Free: 1800 708 5545 Email: [email protected] WINTERIZATION INSTRUCTIONS WINTERIZATION COVER ATTACHMENT PLACE WINTERIZATION COVER ONTO CLAMP RING AT 10 O’CLOCK AND TURN CLOCKWISE TO 12 O’CLOCK TO LOCK INTO PLACE ALIGN TERMINAL PINS ON PLUG WITH TERMINAL PINS ON BACK OF WINTERIZATION COVER AND FIRMLY ASSEMBLE PLUG TO COVER 1: CONNECT WINTERIZATION COVER TO PLUG 2: COIL CABLE BACK INTO NICHE 3: LOCK ON WINTERIZATION COVER TO LOCK INTO PLACE: TWIST COLLAR CLOCKWISE A FEW TIMES UNTIL IT’S HAND TIGHT IMPORTANT ENSURE THE COLLAR MARKER STOPS AT OR PAST THE ALIGNMENT MARKER ON THE LIGHT HOUSING