Spa Electrics RETRO Series Manuals

AQUA/LAMP REPLACEMENT 2 3 4 5 6 7 10 12 13 15 18 CONTENTS PRODUCT SUPPORT & INFORMATION CANADA / NTH AMERICA INTERNATIONAL Select Pool Products Spa Electrics PTY LTD Email: [email protected] www.spaelectrics.com www.selectpoolproducts.ca Tel: 1-855-881-0889 Tel: +61 3 9793 2299 Email: [email protected] 1 READ THIS FIRST / PRODUCT WARNINGS TOOLS REQUIRED / WINTERISATION INCLUDED PARTS BEFORE YOU START EXISTING LIGHT REMOVAL / CABLE PREPERATION CABLE JOINER INSTALLATION LIGHT INSTALLATION LIGHT REMOVAL / WINTERISATION MULTI PLUS SETUP MULTI PLUS - MANUAL OPERATION CERTIFICATION & COMPLIANCE Congratulations on your purchase of a Spa Electrics RETRO Series pool light, for safe and proper installation, please read the installation manual carefully prior to product installation. For safe & proper installation, use only parts (screws, plugs, sealant etc) provided. The RETRO Series EMRX Light must be water cooled at all times. DO NOT switch the light on until installation is complete and the light is fully submerged in water. Ensure sufficient cable is coiled behind the light to allow for servicing Ensure only circular cable not exceeding 14mm diameter is connected to the supplied cable joiner. The use of Figure 8 or non circular cable will prevent correct sealing & will void the product warranty. The RETRO Series EMRX Light does not contain any user serviceable parts, opening the light will void the product warranty. Pool chemicals & PH levels: Due to the corrosive nature of unbalanced pool chemi- cals, Spa Electrics strongly recommends that your pool water is balanced prior to installing your pool Lights or any plastic or stainless steel components, and tested weekly to maintain these levels. pH levels should be maintained between 7.2- 7.6 at all times to ensure the longevity of these components. Failure to do so can result in chemical damage to the light housing and pool fittings, including stainless steel components. Please note: Lights or components found to have excessive chemical damage will not be covered under our manufacturer’s warranty policy READ THIS FIRST WARNING The RETRO Series light must only be used with a UL listed 12V AC Class 2 power supply or a power source intended for swimming pool use (not included). Minimum power source wattage requirement - 15 Watts per light. ELECTRICAL SUPPLY NOTICE 2 TOOLS REQUIRED Side cutters / Pliers Small flat-blade screwdriver (supplied) 24mm / 29mm spanner (supplied) • The use of power tools during installation is not recommended as these devices can cause faults and damage to light components. • All installation steps should be carried out with manual tools only. • The enclosed images are for illustrative purposes only. Appearances of parts and assemblies may vary from the enclosed illustrations. • Please contact your reseller if you have any questions regarding the correct installation of this product. IMPORTANT NOTES WINTERIZATION • All RETRO Series lights must be removed from niche (Pg.12) and lowered to pool floor during periods of pool water freezing. • Pre-existing niches should be adequately protected during winter months as per manufacturers recommendations. • Consult your local pool professional for complete pool winterization process. 3