STA-RITE PLM100 Manuals

INSTALLING DECALS: (Tank Upper Half Only): 1. Make sure replacement upper half is clean and dry. Apply decals as shown. 2. Read warning and operating instruction decals. DISASSEMBLY: 1. STOP PUMP; CLOSE isolation valves. OPEN air release valve and drain fitting. Drain all water from tank. 2. WAIT until all pressure is released and water drained from filter tank and system before loosening Posi-Lok™ Ring. 3. Remove Posi-Lok™ ring as follows: a. Press safety latch (below the ring) toward tank to release it (Figure 1). b. Hold latch in the release position and rotate ring COUNTERCLOCKWISE to remove. If ring is difficult to turn, tap gently with a rubber mallet. NOTICE: DO NOT use a screwdriver or sharp blade to pry tank shells apart. 4. Separate upper and lower tank shell halves using tabs on bottom of Posi-Lok™ ring. Insert tab into slot located at tank joint and twist ring to pry shell halves apart (See Figures 2 and 3). 5. Remove O-ring from upper tank shell. Inspect for cuts, cracking, deformation or signs of wear; replace if necessary. NOTICE: To avoid strain or damage, allow filter module to drain before lifting it out of the tank. 6. When replacing lower tank half, install internal tank parts in new tank. Connect to plumbing as in original installation. (Continued on back of sheet) Sta-Rite Replacement Upper/Lower Half Filter Tank Kit Instructions E R I A S E A L E R E U E G A E R G U S S R P C O L O M E V E K R M E V O R E K L C O K O L C V E M R O E RELEASE Sta-Rite Pool/Spa Group 293 Wright Street, Delavan, WI 53115 International: 262-728-5551, FAX: 262-728-7550 www.starite.com Union City, TN • Delavan, WI • Mississauga, Ont. • Murrieta, CA © 2004, Sta-Rite Industries Printed in U.S.A. S380 (Rev. 8/24/04) Nameplate Decal Logo Decal Warning Decal Operation Instructions Decal Hazardous pressure. Can cause severe injury from tank blow up. Release all pressure and read instructions before working on filter. Figure 2 – Insert ring tab in slot in filter body. Figure 3 – Roll ring to one side to loosen upper tank half. Depress Safety Latch to unscrew Posi-Lok™ RELEASE RELEASE Figure 1 – Depress safety latch to unscrew Posi-Lok™ Ring.