Document Preview & Text Transcription
Owner‘s Manual
FOG MACHINE
SF-1000
- 2 -
Thank you for choosing one of our fog machines. You now own a rugged
and powerful state-of-the-art machine. Prior to use, we suggest that you
carefully read all of the instructions. By following the suggestions found
in this user manual, you can look forward to the reliable and satisfactory
performance of your fog machine for years to come.
1. Cautions
For your own safety you must read this section in full
first!
Never drink fogger liquid. If it is ingested, call a doctor immediately. If
•
Fogger liquid comes in contact with skin or eyes, rinse thoroughly with
water.
Do not overfill your
•
fog machine. Overfilling will cause the unit to clog.
If your
•
fog machine fails to work properly, discontinue use immediately.
Drain all fogger liquid from the tank, pack the unit securely (preferably
in the original packing material), and return it to your fogger dealer for
service.
Danger of electric shock or burns
Keep this device dry. For inside use only. Not designed for outside use.
•
For the 230V models, use 3-prong grounded electrical outlet only. Prior to
•
use take care to determine that the unit is installed at the rated voltage.
Always unplug your
•
fog machine before filling its tank.
Keep Fogger upright.
•
Turn off or unplug when not in use.
•
This machine is not water-or splash proof. If moisture, water, or fog
•
liquid gets inside the housing, immediately unplug the unit and contact a
service technician or your fogger dealer before using it again.
No user serviceable parts inside. Refer to your Fogger dealer or other
•
qualified service personnel.
The output nozzle becomes very hot during operation (300 °C). Keep
•
flammable materials at least 60 cm away from the nozzle.
Always allow your fog machine to cool down before attempting to clean
•
or service it.
For adult use only. Fogger must be installed out of the reach of children.
•
Never leave the unit running unattended.
•
Never aim the output at open flames.
•
- 3 -
Danger of explosion
Never add flammable liquids of any kind (oil, gas, perfume) to the
•
fog
machine liquid or the fluid container.
Pay attention to all warning labels and instructions printed on the
•
exterior of your fog machine.
Never let the fogger close up to any flame, flammable or explosive
•
substance to avoid fire and explosive.
Use only high-quality liquid or suitable dealer recommended fog fluid.
•
Always make sure there is sufficient liquid in the
•
fog machine liquid
tank. Operating this unit without liquid may cause permanent damage to
the machine.
2. Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to
•
operate the system has arrived intact.
Your
•
fog machine should be accompanied by the following items:
1.
This user manual!
2.
Power cord
3.
Multi-function remote control with attached cord
If any equipment is missing contact your
•
fog machine dealer immediately.
Please also contact your vendor when you find any destroyed or
•
omitting parts.
Before beginning initial setup of your
•
fog machine, make sure that there
is no evident damage caused by transportation. In the event that the
unit’s housing or cable is damaged, do not plug it in and do not attempt
to use it until after contacting your fog machine dealer for assistance.
3. Setup
Remove all packing materials from shipping box, check that all foam
•
and plastic padding is removed, especially in the nozzle area.
Place the fog machine on a flat surface and remove liquid tank cap.
•
Pour high quality fog water-based liquid into the liquid tank, being
•
careful not to exceed the maximum fluid level. DO NOT OVERFILL. Use
only our Fogger Liquid or other dealer-recommended high-quality fog
fluid. Any other types of fluid can damage the unit. When the container
is full, place the cap back on the liquid tank and tighten.
Firmly attach remote control cable to the proper input on the rear of the
•
machine.
- 4 -
4. Operation
Plug the power cord into a properly wired and grounded electrical outlet.
•
Turn the power switch on rear of unit to position “ON”.
Once the red light comes on the machine must warm-up .This period
•
varies depending on conditions but should not take more than 10
minutes under any circumstances.
The green light on the remote control will turn on once the machine is
•
ready to produce haze. When the green light turns on, the machine may
be operated using the remote control. Prior to the green light turning on
the machine will not haze and the functions will not respond.
The fog machine is controlled via the remote control. Please refer to the
•
section titled Remote Control Operation for detailed instruction on the
various functions available.
The remote unit’s lamp will cycle on and off as the machine re-heats to
•
the proper operating temperature.
As your model includes a mounting bracket designed for overhead
•
installation, it may be installed at floor level or suspended overhead. If
the unit is to be mounted using the bracket, it is important that the fog
does not shoot directly at any one’s face. Whatever installation method
you choose, do not allow the unit to have more than a 15 degree angle
of inclination.
Important:
Always monitor tank fluid level during operation. The fog machine can
suffer damage when run without fluid. If the machine does not function after
having been run without fluid, please contact your Fogger dealer for service.
Remote Control Operation
The INTERVAL knob adjusts the time between discharges when the
•
timer function is engaged. The range is from 10 ~ 180 seconds.
The second knob labelled “DURATION” controls the duration of the
•
haze blast produced. The range is from 1 ~ 10 seconds.
The yellow TIMER button controls the timer function. Depress the
•
button to activate it. When activated the yellow light will turn on.
Adjusting the interval knob will determine the time between haze output
(10 ~ 180 seconds).
The green MANUAL button will produce a continuous blast at maximum
•
volume while the button is held down. When released, the manual
function stops and the machine will return to the previous setting.
