StarTech.com MCM1110SFP Manuals

Instruction manual DE: Bedienungsanleitung - de.startech.com FR: Guide de l'utilisateur - fr.startech.com ES: Guía del usuario - es.startech.com IT: Guida per l'uso - it.startech.com NL: Gebruiksaanwijzing - nl.startech.com PT: Guia do usuário - pt.startech.com Manual Revision: 09/01/2015 For the latest information, technical specifications, and support for this product, please visit www.startech.com/MCM1110SFP. Packaging contents • 1x fiber media converter with open SFP slot • 1x universal power adapter (NA/EU/UK/AU) System requirements • MSA-compliant Gigabit SFP module (Mini-GBIC) • 10/100/1000 Mbps Ethernet network equipment • RJ45 terminated UTP Cat5e or better Ethernet cable • Terminated fiber-optic cable (dependent on the SFP transceiver module used) • AC electrical outlet Product diagram Front view Rear view MCM1110SFP Gigabit Ethernet Fiber Media Converter with Open SFP Slot LEDs LFP DIP switch SFP slot RJ45 port DC input port Install the media converter 1. Turn off the networking equipment that will be connected to the media converter. 2. Remove the dust cover and insert a Gigabit MSA-compliant SFP module into media converter’s SFP slot. The SFP transceiver used should depend on your fiber network infrastructure. Note: The media converter can only be used with Gigabit SFP modules and will not support 10/100Mbps modules. 3. Connect a duplex fiber-optic cable from the media converter’s SFP module to your fiber network device. The TX and RX connectors must be paired at both ends of the connection. For example TX to RX, and RX to TX. 4. Connect an RJ45 Cat 5e/6 Ethernet cable from the media converter’s RJ45 port to your 10/100/1000Mbps network device. 5. Select the appropriate regional clip for your region and connect the power adapter to an AC electrical outlet. 6. Connect the power adapter to the media converter’s DC input. The PWR LED (power) should light up solid. 7. Turn the networking equipment from step #1 back on. The Fiber and TP LNK/ACT LEDs should light up solid when all cables and devices are properly connected. Note: Check the link budget of your SFP modules, as well as the module’s intended wiring distance. SFP modules are designed to transmit signals over large distances. If the physical wiring distance is too short, the transmitting optical signal (laser) may be too strong and damage the receiving SFP module. An in-line optical attenuator may be required to protect them from damage. LED indicators LED Status Indication PWR (Green) Solid The media converter is powered on Fiber LNK/ACT (Green) Solid A fiber link between the media converter and fiber network equipment is established Flashing The fiber port is actively sending or receiving data (activity) TP LNK/ACT (Green) Solid An RJ45 Ethernet link between the media converter and RJ45 network equipment is established Flashing The RJ45 port is actively sending or receiving data (activity) TP 1000 (Green) Solid A Gigabit (1000Mbps) link on the RJ45 port is established Off The RJ45 port is running at 10/100Mbps speeds