Sterling Power Products ProCharge U Manuals

The ultimate battery charger 12V 60A model, all other units pro rata Input voltage range 90-270V 40-70Hz Power Factor at 230V 0.95 Efficiency 88.5% Full load current ( 110/230v ) 10 /4.8 Ripple noise ( R.M.S. ) 50mV Ground leakage 0.75 mA Generator/ mains power required to run unit ( watts ) 12 v 20 amp approx 300 watts 12 v 30 amp approx 450 watts 12 v 40 amp approx 600 watts 12 v 50 amp approx 750 watts 12 v 60 amp approx 900 watts 24 v 20 amp approx 600 watts 24 v 30 amp approx 900 watts volt metre accuracy +/- 1.5% amp metre accuracy +/- 1% Tested to CE standards EN61000-3-2 EN61000-3-3 EN55014-1 EN 55014-2 EN60335-2-29 ProCharge U DANGER HIGH VOLTAGE AVOID SERIOUS INJURY OR DEATH FROM ELECTRICAL SHOCK. BEFORE PERFORMING ANY ELECTRICAL WORK TURN OFF AC POWER SUPPLY DANGER EXPLOSION HAZARD AVOID SERIOUS INJURY OR DEATH MAKE CONNECTIONS IN AN ATMOSPHERE FREE OF EXPLOSIVE FUMES WARNING LOW VOLTAGE AVOID SERIOUS INJURY FROM ELECTRICAL BURNS AND SPARKS. BEFORE PERFORMING ANY ELECTRICAL WORK DISCONNECT ANY DC POWER SUPPLY FROM UNIT CAUTION HOT SURFACES – TO REDUCE RISK OF BURNS DO NOT TOUCH WHILE IN SERVICE CHARGE ONLY USER SELECTED TYPE BATTERIES (Flooded, AGM, GEL, lithium or Calcium) OTHER TYPES OF BATTERIES MAY BURST CAUSING PERSONAL INJURY AND DAMAGE RISK OF ELECTRIC SHOCK, NO USER SERVICEABLE PARTS, RETURN TO MANUFACTURER FOR SERVICING THIS UNIT IS IGNITION PROTECTED Top Function 1) 11 pre programmed battery curves including LiFePO4. 2) 1 custom set, can be set from charger, no need for computer. 3) 2 x digital meters for current and voltage measurement. 4) 1 x power meter to show what reserve power left on the unit. 5) PFC, active, up to 0.99 pf, ensuring efficient power conversion, up to almost 90% as opposed to about 50% for older non PFC technology. 6)New synchronised rectification output as opposed to diode output, giving up to an extra10% efficiency 7) High voltage de-sulphation cycle. 8) New, low activity, standby mode to increase battery life. 9) Battery health program. 10) Multiple speed fan control to reduce unnecessary fan noise experienced by the customer, even though the new extreme efficiency reduces the need for fans, at high ambient temperatures: ( 40-50 deg C ) fans would still be required to ensure operation. 11) Primary ( processor digitally controlled ) and an emergency backup secondary (analogue controlled) high voltage trip. 12) 32 LED information pane. 13) Internal scan and systems check. 14) Remote control 15) Small footprint and light weight 16) Include battery temperature sensor 17) As with all our marine chargers no exposed ferrous metals used, only aluminium/stainless steel/copper /brass/gold, exposed to air. 18) % power reduction to allow unit to work with restricted power available ( available on local control or remote control panel ), 19) Conforms to A.B.Y.C. drip test, is water proof from water directly dropped on to the top of the unit ( +/ - 17 deg ) if installed correctly (vertically) 20) The printed circuit boards are conformal coated for high humidity operations. This product requires a knowledge of both a/c and d/c electrical installation. Please do not install or attempt to install this product unless you are qualified to do so. All effort is made to make the instructions as safe as possible but it is not possible to cover all electrical safety and installation aspects. Sterling can only assume a certain basic knowledge is held by the installer. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision of instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Pro Charge ULTRA GLOBAL A/C Input & Active Power Factor Correction Sterling Power OK CHARGER MODE AC Power Auto Temp Control Active PFC Multi Speed Cooling Volts Amps AUTO CONSERVATION MODES Fault Absorption Stand-by Battery Health Program Fast Charge Float DC Output Fault DC Low Voltage DC High Voltage Trip High Charger temp trip Check Fan De-sulphation 1 2 3 SETUP ENTER CHARGE INFORMATION Open lead acid Sealed lead acid A.G.M GEL Calcium / Custom Lithium (LiFePO4)* System self test Battery Type Charger Output 0% 100% High current capable of causing sparks burns and fires, always disconnect the D/C cables from the batteries before working on the D/C side. Intended for both COMMERCIAL and DOMESTIC use. To avoid serious injury or death from electric shock. Before opening, turn off the main A/C power. Do not expose to rain nor spray. Replace defective wires/cords before use. Always read the manual before operating the charger. Progressive DIGITAL software control Charger / Powerpack RoHS compliant High Voltage A/C Low Voltage D/C WARNING www.sterling-power-usa.com Preset 1 Preset 2 www.sterling-power.com *Lithium must be used in conjunction with a lithium balancing system. Safety Certified by: TUV Built and tested to UL 1236 SB CSA C22.2-107.2 Safety Certified by: To Standards: UL 1236 SB CSA C22.2-107.2 RoHS compliant EN ISO 13297 Small Craft Directive