Stryker 6390 Manuals

2017/09 D.2 6390-009-002 REV D www.stryker.com Maintenance Manual Power-LOAD® Cot Fastener System 6390

www.stryker.com 1 6390 Angle Position Sensor (APS) Calibration Instructions TOOLS REQUIRED •� Stryker�EMS�USB�Tool •� Male-to-Male�USB�Cable •� T25�Torx�Driver •� Tape�Measure PROCEDURE 1.� Place�the�vehicle�on�a�level�surface.� 2.� Make�sure�that�the�Power-LOAD�main�power�is�turned�on. 3.� Press�and�hold�the�release�lever�at�the�foot�end�of�the�Power-LOAD�system�and�pull�to�remove�the�cot�from�the� vehicle�patient�compartment.�� Note: The head end LED indicators turn solid green only when the cot is ready to unload. 4.� Unload�the�cot�from�the�vehicle: •� For cot models 6500/6506 & 6510/6516: 1.� Press�and�hold�the�extend�(+)�button�on�the�cot�control�switch�to�extend�the�cot�base�until�the�cot�wheels� rest�on�the�ground. 2.� Release�the�extend�(+)�button�after�the�cot�is�no�longer�supported�by�the�lifting�arms.�The�lifting�arms�will� continue�moving�until�they�have�fully�lowered.�Do not unlock the cot from Power-LOAD. •� For cot models 6085/6086: 1.� Operator�1�(foot�end)�-�Grasp�the�cot�frame�at�the�foot�end.��Squeeze�and�hold�the�cot�manual�release. 2.� Operator�2�(side)�-�Grasp�the�base�frame,�lift�slightly,�and�lower�the�base�frame�to�its�fully�extended� position.�Verify�that�the�base�is�fully�extended. 3.� Operator�1�(Foot�End)�−�Release�the�cot�manual�release�to�lock�the�undercarriage�into�the�extended� position. 4.� Press�the�down�()�button�on�the�Power-LOAD�control�panel�to�lower�the�lifting�arms�and�cot.��Do not unlock the cot from Power-LOAD. 5.� Using�a�T25�Torx�driver,�remove�the�two�screws�(A)�that�secure�the�cover�to�the�left�wing�assembly�to�gain�access� to�the�USB�port�(Figure�1).��Save�the�screws�and� cover�for�reinstallation.� 6.� Unscrew�the�cap�that�protects�the�USB�port. 7.� Set� the� laptop� with� the� Stryker� EMS� USB� tool� installed�on�top�of�the�cot�mattress�at�the�foot�end� of�the�cot. A Figure 1

2015/02 D.0 6390-309-001 REV D www.stryker.com Power-LOAD™ Cot Fastener System 6390 Operations/Maintenance Manual