Sun Microsystems Netra st D130 Manuals

Netra™st D130 Installation
and Maintenance Manual
Part No.: 806-1489-10
November 1999, Revision A
Sun Microsystems, Inc.
901 San Antonio Road
Palo Alto, CA 94303-4900 USA
650 960-1300
Fax 650 969-9131
Send comments about this document to: [email protected]
Send comments about this document to: [email protected]

Ordering Rackmount Kits
The Netra™ st D130 storage enclosure is shipped out of the factory with
two 19-inch mounting brackets, which can be used to install the enclosure
into most 19-inch racks. Refer to the Netra st D130 Product Notes for
instructions on installing the storage enclosure with these brackets.
If you need to install the enclosure into a 23-inch, 24-inch, or 600 mm rack,
or if you prefer to use rack slide mounts, you must order a separate
rackmount kit from Sun Microsystems, Inc.
Installing the Thumbscrew Rack Brackets
The rackmount kits listed in Table 1 contain documentation describing
how to install the storage enclosure into a rack. However, you must first
replace the factory installed mounting brackets with the thumbscrew rack
brackets included in the Netra st D130 storage enclosure ship kit.
1. Unscrew the two screws that secure each mounting bracket to the
side of the storage enclosure and remove the brackets.
Retain these screws for Step 2.
Figure 1
Removing the Rackmount Brackets
2. Secure each thumbscrew rack bracket to the side of the storage
enclosure using the screws saved from Step 1.
Figure 2
Installing the Thumbscrew Rack Brackets
Note – Refer to the rackmount kit documentation for the rack mounting
procedures.
Table 1
Rackmount Kits
Part Number
Description
X6919A
19-inch Rackmount Kit
X6966A
23-inch Rackmount Kit
X6967A
24-inch Rackmount Kit
X6968A
600 mm Rackmount Kit