Sun Microsystems Sun Fire 15K Manuals

Please Recycle Sun Microsystems, Inc., 4150 Network Circle, Santa Clara, CA 95054 U.S.A. 650 960-1300, Fax 650 969-9131 Sun Fire™ 15K/12K Systems Carrier Plate Configurations Copyright 2002 Sun Microsystems, Inc. All rights reserved. Use is subject to license terms. Third-party software, including font technology, is copyrighted and licensed from Sun suppliers. Portions may be derived from Berkeley BSD systems, licensed from U. of CA. Sun, Sun Microsystems, the Sun logo, Sun Fire, and Solaris are trademarks or registered trademarks of Sun Microsystems, Inc. in the U.S. and in other countries. All SPARC trademarks are used under license and are trademarks or registered trademarks of SPARC International, Inc. in the U.S. and in other countries. Federal Acquisitions: Commercial Software—Government Users Subject to Standard License Terms and Conditions. Copyright 2002 Sun Microsystems, Inc. Tous droits réservés. Distribué par des licences qui en restreignent l’utilisation. Le logiciel détenu par des tiers, et qui comprend la technologie relative aux polices de caractères, est protégé par un copyright et licencié par des fournisseurs de Sun. Des parties de ce produit pourront être dérivées des systèmes Berkeley BSD licenciés par l’Université de Californie. Sun, Sun Microsystems, le logo Sun, Sun Fire, et Solaris sont des marques de fabrique ou des marques déposées de Sun Microsystems, Inc. aux Etats-Unis et dans d’autres pays. Toutes les marques SPARC sont utilisées sous licence et sont des marques de fabrique ou des marques déposées de SPARC International, Inc. aux Etats-Unis et dans d’autres pays. Part Number: 816-0768-11 June 2002, Revision A Accessing Sun Documentation Online A broad selection of Sun system documentation is located at: http://www.sun.com/products-n-solutions/hardware/doc A complete set of Solaris documentation and many other titles are located at: http://docs.sun.com Sun Welcomes Your Comments Sun is interested in improving its documentation and welcomes your comments and suggestions. You can email your comments to Sun at: [email protected] Please include the part number (816-0768-11) of the document in the subject line of your email. Caution – The EMI metal gasket has sharp edges. Handle carefully to prevent bodily injury. 8. If the EMI metal gasket is to be replaced, remove the old gasket by pulling upward from one end, using pliers to avoid injury, until the plastic snaps are released. 9. Install the new gasket by aligning the nine (9) plastic snaps with the row of nine (9) holes at the front edge of the carrier plate, as shown in Figure 4. Using your thumb and forefinger, apply pressure to the snaps until each snap is fully seated into the nine (9) holes and no visible bumps or ridges are showing. FIGURE 4 Installing the EMI Metal Gasket 10. Re-install the expander board on the new carrier plate, as required. 11. Install the carrier plate into the system. 12. Discard any remaining hardware supplied with the FRU package. ! EMI metal gasket Plastic snaps