Swann SWWHD-PTCAM Manuals

Security Made Smarter QUICK START GUIDE 1080p Pan & Tilt Wi-Fi Camera Limited Warranty Terms & Conditions Swann Communications warrants this product against defects in workmanship and material for a period of one (1) year from its original purchase date. You must present your receipt as proof of date of purchase for warranty validation. Any unit which proves defective during the stated period will be repaired without charge for parts or labour or replaced at the sole discretion of Swann. The end user is responsible for all freight charges incurred to send the product to Swann’s repair centres. The end user is responsible for all shipping costs incurred when shipping from and to any country other than the country of origin. The warranty does not cover any incidental, accidental or consequential damages arising from the use of or the inability to use this product. Any costs associated with the fitting or removal of this product by a tradesman or other person or any other costs associated with its use are the responsibility of the end user. This warranty applies to the original purchaser of the product only and is not transferable to any third party. Unauthorized end user or third party modifications to any component or evidence of misuse or abuse of the device will render all warranties void. By law some countries do not allow limitations on certain exclusions in this warranty. Where applicable by local laws, regulations and legal rights will take precedence. FCC Notice This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Simplified EU Declaration of Conformity Swann Communications declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 2014/53/EU. A copy of the Declaration of Conformity can be found at: www.swann.com/uk/compliance Correct Disposal of this product. This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environment safe recycling. QSGPTCAMVER3E | © Swann Communications 2018 Light Sensor Detects ambient light and turns on the infrared LEDS for night vision, if necessary Speaker Ethernet Port Used for wired connection/setup Reset Button Hold for 10 seconds to perform a factory reset. This will reboot the camera and clear all settings to factory defaults, including previously configured Wi-Fi settings, so you can set up your camera again, if needed USB Power Port Restarting your camera can sometimes quickly resolve a problem—just disconnect the USB cable, and then plug it back in MicroSD Card Slot Never miss the moment—Put in a microSD card to record and save motion-activated events Power LED Threaded Mounting Hole (Bottom) Prefer to mount your camera? Just attach the included mounting bracket to the wall, then line the threaded hole on the bottom of the camera up with the threaded stud on the mounting bracket and tighten the knob to secure the camera Connected state ON Unconnected state OFF Wi-Fi LED Microphone Infrared LEDS Dual-Band Wi-Fi Antenna Getting to know your Pan & Tilt Wi-Fi Camera ENGLISH NEED HELP? [email protected] support.swann.com