The Siemon Company S210 Manuals

S210® Wiring Block Instructions S210 Wall Mount Mount the S210™wiring base and legs onto a suitable mounting surface with the necessary screws and hardware. 1 Remove the S210 wiring base from the legs by depressing the outer 4 fanning strips of the S210 wiring base inward to defeat the leg latches. Pull the wiring base away from the legs. Note: Legs are detachable on the 64-pair version only. 2 S210 Rack Mount Mount S210 19 inch panel onto the rack using the #12-24 screws and washers provided. 5 Lace the cables through the appropriate openings in the S210 base. Proceed to step 9 for ter- minating instructions. 6 With the S210 base removed, route the cable between the legs. 3 Lace the cables through the appropriate openings in the wiring base and snap the S210 wiring base back onto the legs. Push the wiring base onto the legs until the latches “snap” into place. Proceed to step 9 for terminating instructions. Note: For additional security, the assembly can be fastened together using the self- tapping, Phillips-head screws included. 4 S210 Wiring Block Strip back only as much cable jacket as is necessary to terminate the conductors using the Siemon AllPrep™Cable Preparation Tool (P/N: CPT-RGTP) or equivalent. Note: It is not recommended to strip more than 76mm (3 in.) of cable jacket for category 5 or higher installations. 9 Lace the conductors into the S210 wiring base. Pair twist must be maintained to within 12mm (.5 in.) of the point of termination for category 5 or higher installations. Ample channel space is provided to allow jacketed cable to continue close to the point of termination. Note: The Pyramid™wire entry system on the base and block will separate twisted conduc- tors without special preparations or handling. 10 S210 S89 Retainer Mount Mount S89B or S89D bracket onto a suitable mounting surface with the necessary screws and hardware. Route the cable through the center channel of the bracket. 7 Lace the cables through the center hole of the S210™89 retainer and snap the retainer onto the S89 bracket. Proceed to step 9 for terminating instructions. 8