Thermon Terminator ZP-S Manuals

Power Connection Kit Installation Instructions Terminator ZP-S For Power Connection (1-3 Cables), In-Line Splice Connection, T-Splice Connection, or End Termination (1-2 Cables) Applications for use with HPT power-limiting and FP constant watt heating cables IP66 NEMA/Type 4X -60°°°°°C ≤≤≤≤≤ Ta ≤ ≤ ≤ ≤ ≤ +55°°°°°C Listed Heat Tracing Cable System 137M Ordinary & Hazardous Locations Class I, Division 2, Groups A, B, C & D Class II, Division 2, Groups F & G, Class III Class I, Zone 1, AEx e II T4/T6 Ex e II T4/T6 0539 II 2 G & D EEx e II T4/T6 01ATEX0021995 Warnings Due to the risk of electrical shock, arcing and fire caused by product damage or improper usage, installation or maintenance, a ground-fault protection device is required. Installation must comply with Thermon requirements and be installed in accordance with the NEC, CEC, or any other applicable national and local codes. Component approvals and performance ratings are based on the use of Thermon specified parts only. User supplied power connection fittings must be European certified for EEx e or UL Listed or certified for AEx e (North America only). De-energize all power sources before opening enclosure. Keep ends of heating cable and kit components dry before and during installation. Kit Contents 1 2 Tools Required Certifications/Approvals 1 2 4 5 3 6 7 8 9 11 10 2 1 Junction Box Lid 3 1 Junction Box Base w/ O-ring 4 1 Nut 5 1 Banding 6 1 RTV Tube 7 3 Power Connection Boots 8 1 Banding Guide 10 3 Ground Sleeves Item Qty Description 1 1 Expediter Assembly Support Cap w/ O-ring Threaded Grommet Compressor Grommet Support Base w/ O-ring 11 1 Junction Box Cord 9 1 Terminal Blocks w/ DIN Rail (Refer to terminal specifications for maximum allowable wire size) Installation Instructions 3 4 Locate bus connection and cable as shown. Cut end of cable at angle to aid in piercing grommet. Leave additional cable for expansion loop. See pages 11-12 for multiple cable installation tips. 1. Insert cable into expediter. If mounted on bottom of pipe, punch out weep hole. 2. Slide expediter toward pipe and route cable through support base entry. 3. Insert banding guide into expediter and snap into place. 4. Mount expediter to pipe using pipe band. Do not band over cable. 5. Cut off end of cable. 6.